Reset To Factory Settings; Jumper Settings - EVERSPRING SE801 Guía De Usuario

Manual Binding
1. Locate the Control Box area and remove its waterproof cover by
unscrewing it. Identify the Link button inside.
Control
Box
Cover
2. With the 9V battery still connected, repeat steps 5 to 6 of the Binding with
Homesys section.
3. Press and hold the Link Button for more than 4 seconds until the Strobe LED
starts to flash rapidly then release.
4. Within 5 seconds the Strobe LED will stop flashing and turn off, indicating the
binding procedure is completed. The screen below will appear to confirm this.

Reset to Factory Settings

1. Press and hold the Link Button for more than 4 seconds until the Strobe LED
starts to flash rapidly then release.
2. Press and hold the Link button again for more than 6 seconds until the Strobe
LED turns off, then release. The LED will flash every 2 seconds indicating the
siren is now reset back to factory mode factory.

Jumper Settings

The siren preset settings can be modified by adjusting the jumper settings inside its
Link Button
Control Box.
1. Locate the Control Box area and remove its waterproof cover by unscrewing it.
2. Identify the set of jumper links JP1. The settings for each is described below:
4
JP1
Position Jumper fitted
ALARM Alarm sound enabled
CU Must be fitted
1MIN 1 minute alarm sound
ANTI Anti-jamming enabled
BEEP Beep sound enabled
JP1 Settings
Jumper removed
Alarm sound disabled
N/A , factory use only
3 minute alarm sound
Anti-jamming disabled
Beep sound disabled