Getting Started; Turning Power On And Off; Detaching And Attaching The Front Panel; Initial System Start-Up - Alpine CDE-9845 Manual De Operación

Getting Started

CDE-9845
SOURCE/POWER Rotary encoder
MUTE/SETUP
CDE-9843
SOURCE/POWER Rotary encoder
MUTE/SETUP
CDE-9841
SOURCE/POWER
MUTE/SETUP

Turning Power On and Off

Press SOURCE/POWER to turn on the unit.
• The unit can be turned on by pressing any other button except eject
c and TITLE .
Press and hold SOURCE/POWER for at least 2
seconds to turn off the unit.
• The first time power is turned on, the volume will start from level 12.

Detaching and Attaching the Front Panel

Detaching
1
Turn off the unit power.
2
Press (Release) at the lower left side until the
front panel pops out.
c
c
4/3
c
3
Grasp the left side of the front panel and pull it out.
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel.) This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
Attaching
1
Insert the right side of the front panel into the main
unit. Align the groove on the front panel with the
projections on the main unit.
2
Push the left side of the front panel until it locks
firmly into the main unit.
2
• Before attaching the front panel, make sure that there is no dirt or
dust on the connector terminals and no foreign object between the
front panel and the main unit.
• Attach the front panel carefully, holding the sides of the front panel
to avoid pushing buttons by mistake.

Initial System Start-Up

Be sure to press the RESET switch when using the unit for the first
time, after changing the car battery, etc.
1
Turn off the unit power.
2
Remove the detachable front panel.
3
Press RESET with a ballpoint pen or similar
pointed object.
RESET switch

Adjusting Volume

Turn the Rotary encoder (CDE-9845/CDE-9843 only)
or press 4 4 4 4 4 and 3 3 3 3 3 (CDE-9841 only) until the desired
sound is obtained.

Lowering Volume Quickly

Activating the Audio Mute function will instantly lower the volume
level by 20 dB.
Press MUTE/SETUP to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing MUTE/SETUP again will bring the audio
back to its previous level.
1 1
1
5
-EN