Ecco C2013B Instrucciones De Instalación página 2

Specifications:
CAMERA
Image
Voltage Requirement
Effective Pixels
Power Consumption
Lens Size
Lens Angle
Audio
Light Sensor
Infrared LEDs
Pigtail Connection: CAM
Housing
Mech. Vibration
Mounting
Weight
Dimensions (WxHxD)
Operating Temp.
IP Rating
Approvals
Current Consumption
!
Caution! When drilling into any vehicle surface, make sure that the area is free from any electrical wires, fuel lines,
vehicle upholstery, etc. that could be damaged.
Notes:
1. Larger wires and tight connections will provide longer service life for components. For high current wires it is recommended
that terminal blocks or soldered connections be used with shrink tubing to protect the connections. Do not use insulation
displacement connectors (e.g., 3M Scotchlock type connectors)
2. Route wiring using grommets and sealant when passing through compartment walls. Minimize the number of splices to
reduce voltage drop. High ambient temperatures (e.g., under-hood) will significantly reduce the current carrying capacity of
wires, fuses, and circuit breakers. All wiring should conform to the minimum wire size and other recommendations of the
manufacturer and be protected from moving parts and hot surfaces. Looms, grommets, cable ties, and similar installation
hardware should be used to anchor and protect all wiring.
3. Fuses or circuit breakers should be located as close to the power takeoff points as possible and properly sized to protect the
wiring and devices.
4. Particular attention should be paid to the location and method of making electrical connections and splices to protect these
points from corrosion and loss of conductivity.
5. Ground termination should be only be made to substantial chassis components, preferably directly to the vehicle battery.
6. Circuit breakers are very sensitive to high temperatures and will "false trip" when mounted in hot enviroments or operated
close to their capacity.
C2013B
CMOS
12V
725 x 488
1W
1/4"
120°
No
Auto Switch B&W
18
Male 4 Pin Threaded
Aluminum Alloy
8g
Rear/Front
0.58 lbs
2.92"x3.01"x2.62"
-4°F to 158°F
IP69K
FCC,CE,RoHS
175mA Max
MONITOR
Screen Size
Controller
Voltage
Power
Mirror Imaging
Resolution
System
Viewing Angle
Visible Area
Contrast
Split Screen Feature
AV Compatible
DVR Compatible
Audio
Brightness
Light Sensor
Camera Selection
Connection: CAM
Connection (Monitor Pigtail)
Connection: CB
Housing
Mounting
Mech. Vibration
Weight
Dimensions (WxHxD)
Operating Temp
Remote Control
Approvals
M7000B
7" (4:3) and (16:9)
2 Camera
12-24 VDC
Approximate: 5W
Yes (via Camera and Monitor Switch)
800(W)XRGBX480(H)
PAL/NTSC
L/R/U/D: 60º/60º/40º/60º
154X86mm
400:1
No
Yes
No
No
400cd/m2
Auto Dim
1-2 Via Trigger Wires
Female 4 Pin Threaded
Male 9 Pin
N/A
Plastic
Pedestal
Pedestal Bracket - 3G
0.88 lbs
6.85" x 4.49" x 0.94"
-4°F to 158°F
Yes
FCC,CE,RoHS
Page 2 of 16