Parallel Guide; Maintenance - Truper ROU-NX3 Manual De Instrucciones

Operation

Parallel Guide

• Fix the parallel guide (G) in the router base (page 8) and
support it in the work piece edge to make straight cuts.
Bits with Guide Stopper
• Bits built with an incorporated stopper are ideal for
edges. The work piece by itself can serve as a guide when
its thickness is higher than the bit height (H). If the work
piece has a smaller thickness than the bit height use a
guide (I) to make the cut.
H

Maintenance

• Double-check the machine ventilation slots are free of sawdust, chips, etc.
• Keep the guides clean and lubricated using multi-purpose light oil.
Repair Service
• The tool repair service shall always be carried out in a
the machine are carried out personnel not authorized by
Carbon Brush Replacement
• It is necessary to replace worn (burnt, broken or smaller then 0.19" long),
carbon brushes with new ones.
• When replacing carbon brushes always replace both carbons.
• Remove the worn carbon brushes from their housing. Remove the
accumulated dust with compressed air.
• Set the new carbon brushes reversing the order. The carbon brushes shall fall
easily into the housing.
• After setting the new carbons make the router run unloaded a couple of
minutes to let the carbon brushes have a better fit.
• Use only original
designed with the hardness and electric resistance adequate for each type of
motor. The carbon brushes that are out of specification may damage the motor.
I
spare carbon brushes specifically
Authorized Service Center. If the repair service in
, the Warranty will be made void.
Carbon
Brushes Cap
G
11
ENGLISH