Craftsman 917.379380 El Manual Del Propietario página 11

l'l'lli#lTVl.1
I ,_.'.'.'.'.'.'.'.'.-IP F--.,lli'i FIVillltl I IVltl._l
SERfALNUMBER
DATE OF PURCHASE
GASOLINE CAPACITY/TYPE:
:OIL TYPE (API-SF!SG!SH):
OIL CAPACITY:
SPARK PLUG (GAP: .030',)
VALVE CLEARANCE:
1.5 QUARTS
UNLEADED REGULAR
SAE 30 (ABOVE 32°F)
SAE 5W-30 (BELOW 32°F ) ...............
20 OZS.
CHAMPION RJ19LM OR J19LM
INTAKE: .004 - ,008
EXHAUST: .004 - .008
SOLID STATE IGNITION
AIR GAP: .0125 fN,
BLADE BOLT TORQUE: 35-40 FTo LBS.
• _T5i_ ni0det and s'erial numbers will be found on a de_,a attached to the rear 6fthe
lawn mower housing.Record both serial number and date of purchase in space
provided above.
LAWNMOWER
Always obseive safety rules when performing
any maintenance.
TIRES
• Keep tires free of gasoline, oil, or insect
control chemicals which can harm rubber.
o Avoid stumps, stones, deep ruts, sharp
objects and other hazards lhat may cause
tire damager
BLADE CARE
For best results, mower blade must be
kept sharp, Replace bent or damaged
blades.
TO REMOVE BLADE
o Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with spark plug.
', Turn lawn mower on its side. Make
sure air filter and carburetor are up.
,, Use a wood block between blade and
mower housing to prevent blade from
turning when removing blade bolt.
° Protect your hands with gloves and/or
wrap blade with heavy cloth.
• Remove blade bolt by turning counter-
clockwise.
o Remove blade and attaching hardware
(bolt, lock washer and hardened
washer).
NOTE: Remove the blade adapter and
check the key inside hub of blade adapter.
The key must be in good condition to work
properly. Replace adapter if damaged.
TO REPLACE BLADE
• PositJon the blade adapter on the
engine crankshaft° Be sure key in
adapter and crankshaft keyway are
aligned.
• Position blade on time blade adapter
aligning the two (2) holes in the blade
with the raised ILIgS on the adapter_ • Be sure the trailing edge of blade
(opposite sharp edge) is up toward tile
engine.
,, Install the blade bolt with the lock
washer and hardened washer into
blade adapter and crankshaft°
o Use block of wood between blade and
lawn mower housing and tighten the
blade bolt, turning clockwise.
° The recommended tigl_tening torque is
35-40 fL Ibs.
1t