Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Check the fuel level periodically
to avoid running out
of gasoline
while operating
the chipper-shredder.
If
the unit runs out of gas as it is shredding or chipping,
it may be necessary to unclog the unit before it can be
restarted.
Refer to "Removing
the Flail Screen"
in
SERVICE AND ADJUSTMENT
section.
WARNING: EXPERIENCE
INDICATES THAT ALCO-
HOL BLENDED
FUELS (CALLED
GASOHOL
OR
USING ETHANOL OR METHANOL)
CAN ATTRACT
MOISTURE
WHICH LEADS TO SEPARATION
AND
FORMATION
OF ACIDS
DURING
STORAGE.
ACIDIC GAS CAN DAMAGE
THE FUEL SYSTEM
OF AN ENGINE WHILE IN STORAGE.
TO AVOID
ENGINE
PROBLEMS,
THE
FUEL
SYSTEM
SHOULD BE EMPTIED OR TREATED
WITH FUEL
STABILIZER
BEFORE
STORAGE
FOR 30 DAYS
OR LONGER.
USE FRESH FUEL NEXT SEASON.
SEE "STORAGE"
SECTION
FOR ADDITIONAL
INFORMATION.
NEVER USE ENGINE OR CARBURETOR
CLEAN-
ER PRODUCTS
IN THE FUEL TANK OR PERMA-
NENT DAMAGE MAY OCCUR.
Spark Plug,
Wire and
Fuel
Tank
FIGURE 11.
TO STARTENGINE
_
WARNING:
BE SURE NO ONE OTHER
THAN
THE OPERATOR
IS STANDING
NEAR THE CHIPPER-SHREDDER
WHILE
STARTING
OR OPERATING.
DO NOT
OPERATE
THIS
CHIPPER-SHREDDER
UNLESS THE CHUTE DEFLECTOR
HAS
BEEN PROPERLY
INSTALLED
AND iS
SECURED WITH THE HAND KNOBS.
Throttle Control
Starter
Handle
i
FIGURE 12.
• Move choke lever to CHOKE position (See figure
13.).
• Grasp starter handle (see figure 12) and pull rope
out slowly until engine reaches start of compres-
sion cycle
(rope will pull slightly
harder
at this
point). Let the rope rewind slowly.
NOTE: A noise will be heard when finding the start of
the compression
cycle. This noise is caused by the
flails and fingers which are part of the shredding mech-
anism falling into place, and should be expected. In
addition, the flails and fingers will be noisy after the
engine is started, until the impeller reaches full speed.
• Pull rope with a rapid, continuous, full arm stroke,
Keep a firm grip on start handle. Let rope rewind
slowly. Do not let starter handle snap back against
starter.
• Repeat
preceding
two instructions
until engine
fires. When engine
starts, move choke
lever on
engine halfway between CHOKE and RUN.
NOTE:
If engine does not fire after three attempts,
move choke lever halfway between CHOKE and RUN
position and try again. See figure 13.
• Move throttle control to IDLE position for a few min-
utes warm-up.
Move choke lever to RUN position
as engine warms up,
NOTE: In order to idle smoothly,
a new engine may
require 3 to 5 minutes running above slow idle speed.
Idle speed has been adjusted to be correct after this
break-in period.
CHOKE_';_
Position
,,::'"
•.;:;"
J
Choke Lever
OFF
• Attach spark plug wire and rubber boot to spark
plug if necessary. See figure 11.
•
Place the throttle control lever in FAST position.
See figure 12.
FIGURE 13.
Tabla de contenido
