Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TO STOPENGINE
• Move throttle control lever to OFF position. See fig-
ure 13.
•
Disconnect spark plug wire and move away from
spark
plug to prevent
accidental
starting while
equipment is unattended.
ilUll =1
CUSTOMER RESPONSIBILITIES
iii
iiii
i
i
i
iiiiiiiiii
MAINTENANCE
SCHEDULE
f_o_//_.3
AS YOU COMPLETE
/oe'_'-/_'//-
_ "/^_/-°'_-/-_'_/
....
REGULAR SERVICE
/@_//"_"+'_'/'_/
"_/
"-/_<_'/
SERVICE DATES
I--
o
Oil Pivot Points
t'
0
Clean Shredder
"J
-_
i.J
Check Engine Oil
_'
Change Engine Oil
4
_
u.I
._i
2:
Service Air Cleaner
Z
Clean Engine Cylinder
q
_'
uJ
Spark Plug
_"
Muffler
,t
CHECK
GENERALRECOMMENDATIONS
WARNING: ALWAYS STOP THE ENGINE
AND DISCONNECT
THE SPARK
PLUG
WIRE
BEFORE
PERFORMING
ANY
MAINTENANCE
OR ADJUSTMENTS.
ENGINE
ENGINE OIL
Only use high quality detergent oil rated with API ser-
vice classification
SG. Select the oil's viscosity grade
according to your expected operating temperature.
Colder
-=
32°F
_
Warmer
• Periodically
check all fasteners
and be sure they
are tight.
• Follow the Maintenance Schedule above.
CHIPPER-SHREDDER
LUBRICATION
Lubricate the pivot points on the release handle, hop-
per assembly, chute deflector and chipper chute once
a season using a light oil.
CLEANING
• The chipper-shredder may be cleaned by running
water from a hose through
the hopper assembly
and chipper
chute with the engine running. Allow
the chipper-shredder
to dry thoroughly.
• Wash the bag periodically with water. Allow to dry
thoroughly in the shade. Do not use heat.
5W30
SAE 30
NOTE: Although
multi-viscosity oils (SE30, 10W30,
etc.) improve starting in cold weather, these multi- vis-
cosity oils will result in increased oil consumption
when used above 32°F. Check your oil level more fre-
quently to avoid possible engine damage from run-
ning low on oil.
Your four-cycle
engine will normally consume some
oil--therefore, check engine oil level regularly approx-
imately every five hours of operation and before each
usage. Stop engine and wait several minutes before
checking oil level. With engine level, the oil must be to
FULL mark on dipstick (refer to figure 10). Change
engine oil after the first five hours of operation, and
every twenty-five hours thereafter.
10
Tabla de contenido
