Promax SATHUNTER Manual De Instrucciones página 49

SATHUNTER USER'S MANUAL.
Note: We advise to assign two test points to each satellite, the first one with
vertical polarization and the second one with horizontal polarization in
order to guarantee the identification of the satellite.
The key [2] enables you, as you can see at figure 9, to change the selected
test point in a sequential way. Therefore, the test point changes every time that you
press this key. To select a specific test point, press repeatedly this key until the display
shows the name assigned to the desired point.
When you select a satellite test point, the name (four letters maximum) and
frequency assigned to that point is displayed.
Afterwards, if it is detected a signal with a valid transport stream at the frequency
(or frequencies) assigned to this satellite, the instrument will show at the top right corner
the symbols DVB-S o
Additionally it will attempt to obtain, the Network, the first 48 services and the orbital
position of the satellite the antenna is pointing at. When this information is detected, it will
be shown on the display. Sometimes this could cause a reduction in the amount of
identifying text characters.
11/2009
Figure 9.- Rotation of active test points.
Figure 10.- Satellite identification screen.
DVB-S2 depending on the selected transport stream.
Page 17