Removing The Drawer - Electrolux Icon Guía De Uso Y Cuidado

WARNING
ELECTROCUTION HAZARD
• Never attempt to repair or perform maintenance on the appliance until the
main electrical power has been disconnected. Turning the appliance control
"OFF" does not remove electrical power from the units wiring.
• Replace all parts and panels before operating.
Remove Drawers from unit
Begin by pulling out the top drawer.
Remove screws securing drawer to slides.
Pull drawer forward, lift up and out to
clear clips in rear of drawer. Move drawer
forward about 1" (2.5 cm) and set down
on slides. At the right rear corner of the
drawer disconnect the display wire harness.
Remove the drawer from the unit by lifting up
off of the slides. Repeat for bottom drawer
but disregard the harness instructions as
there is no wiring to the bottom drawer.
To replace the air filter:
Fully extend the bottom drawer. The air filter is located on the left lower wall of the cabinet.
Remove the old air filter and replace with a new air filter. See Figure 11.
Filter
housing
Air Filter

Removing the Drawer

Remove screws
Clips
Figure 9a
Figure 10
Gasket
Figure 9
Press and hold
down this tab on
the wire connector
and pull the
connector apart.
Figure 11
13