JOYTECH Nitro Racing Wheel Manual Del Usuario página 4

6
ENGLISH
Leg Supports
The adjustable leg supports are provided with the Nitro Racing Wheel™
so that the wheel can be used when the player is seated without a
suitable level surface to set the wheel on. To attach the leg Supports to
the Nitro Racing Wheel™ please follow the diagram below.
Digital Display Stopwatch
Press 'START/STOP' button once and the Stopwatch will start count-
ing. Press the 'START/STOP' button again to stop counting. To reset
the Stopwatch: Press the 'RESET' button once.
Toggle the display between seconds and 1/10th of a second by press-
ing the 'Stopwatch Counter adjust Button' button.
The Digital Display has two settings of brightness, (high or low). To
select these either of these setting push the SENS button and the
'Stopwatch Counter adjust Button' together at the same time.
8
ENGLISH
FCC Declaration of Conformity
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Note: Any changes or modifications made on the system not expressly
approved by the manufacturer could void the user's authority to
operate the equipment.
Canadian DoC Compliance Statement
This digital apparatus does not exceed the Class B limits for radio noise
emissions from digital apparatus specified in the interference-causing
equipment standard entitled "Digital Apparatus," ICES-003 of the
Department of Communications. This device complies with RSS-210 of
Industry and science Canada. Operation is subject to the following two
conditions: 1) This device may not cause interference, and 2) this
device must accept any interference received, including interference
that may cause undesired operation.