Section 2. General Description; Introduction; Product Dimensions - Jandy VSFHP185DV2A Manual De Instrucciones

Page 6
ENGLISH

Section 2. General Description

2.1

Introduction

Jandy Variable Speed Pumps can be run from 600 RPM to 3450 RPM. This allows you to select the most appropriate
®
speed for your application. The pumps are compatible with all Jandy controllers and Zodiac
pump is driven by a variable speed ECM (Electronically Commutated Motor) directly attached to the pump impeller.
The motor spins the impeller which forces water to flow through the pump. As the speed of the motor is varied, the
flow through the pump is also varied. The adjustable flow rate allows for optimization of flow during the varying
pump cycle requirements. As a result, the energy efficiency of the pump is maximized resulting in cost savings to the
pool owner while also helping to save the environment.
This manual contains information for the proper installation, operation, and maintenance of Jandy variable-speed
pumps. Procedures in this manual must be followed exactly. To obtain additional copies of this manual, visit
Jandy.com.
2.2

Product Dimensions

NOTE
When installing a pump, leave a minimum of two (2) feet (30 cm) of clearance above the pump for removal of
the strainer basket.
A
B
Bolt Holes,
Center to Center
MODEL No.
VSFHP185DV2A
VSFHP270DV2A
VSPHP270DV2A
Figure 1. Variable-Speed Pump Dimensions
Jandy Variable-Speed Pumps
®
D
C
Front Edge of Union
to Center of Bolt Holes
A B
Dimensions Dimensions
10" 6 1/2"
10" 6 1/2"
9 1/8" 9"
|
Installation & Operation Manual
F
G
C D
Dimensions Dimensions
7 3/4" 12 3/4"
7 3/4" 12 3/4"
8 7/8" 14 1/8"
automation systems. The
®
E
E F
Dimensions Dimensions
24 1/2" 9 1/2"
24 1/2" 9 1/2"
27 5/8" 11 5/8"
G
Dimensions
9 1/8"
9 1/8"
9 1/16"