Storage; Disposal - RedMax BCZ400SW Manual De Instrucciones

BCZ400SW
9. Maintenance
Failing to do so could cause the
muffler to become overheated, and
that this in turn could cause the
engine to catch on fire. Always
make sure that the muffler is clean
and free of wood chips, leaves, and
other waste before use.
• Check the intake air cooling vent and
the area around the cylinder cooling
fins after every 25 hours of use for
blockage, and remove any waste which
has attached itself to the brushcutter.
Note that it is necessary to remove the
engine cover shown in (MA7) in order
to be able to view the upper part of the
cylinder.
MA7
• If waste gets stuck and causes
blockage around the intake air cooling
vent or between the cylinder fins, it may
cause the engine to overheat, and that
in turn may cause mechanical failure
(1)
on the part of the brushcutter. (MA7)
(1)
(1) intake air cooling vent (back)
■ PROCEDURES TO BE PERFORMED
AFTER EVERY 100 HOURS OF USE
1. Remove the muffler, insert a
screwdriver into the vent, and wipe
away any carbon buildup. Wipe away
MA8
any carbon buildup on the muffler
(1)
exhaust vent and cylinder exhaust port
at the same time. (MA8)
2. Tighten all screws, bolts, and fittings.
3. Check to see if any oil or grease has
(2) (3)
worked its way in between the clutch
(4)
lining and drum, and if it has wipe it
away using oil-free, lead-free gasoline.
(1) vent
(2) muffer
(3) spark arrester
(4) bolts
US-16
IMPORTANT

10. Storage

• Aged fuel is one of major causes of
engine starting failure. Before storing
the unit, empty the fuel tank and run
the engine until it uses all the fuel left in
the fuel line and the carburetor. Store
the unit indoor taking necessary
measures for rust prevention.

11. Disposal

• When disposing your machine, fuel or
oil for the machine, be sure to allow
your local regulations.