BONFIGLIOLI Vectron ACTIVE Serie Guia De Inicio Rapido página 33

Rated Speed
asynchronous motor.
Setting:
Rated Cosinus Phi
motor.
Setting:
Rated Frequency
the type plate of the asynchronous motor.
Setting:
Rated Mech. Power
nous motor.
Setting:
Switching Frequency
configuration (configuration 110: 2 kHz, configuration 410: 4 kHz). Higher switching frequencies
reduce the noise of the motor but require a reduction of the output current (see technical data in
the operating instructions manual).
Setting:
Min. Switching Frequency
automatically in the case of a thermal overload of the frequency inverter.
Setting:
Minimum Frequency
S2IND, S3IND results in an acceleration of the drive to the minimum frequency.
Setting:
Maximum Frequency
quency of the frequency inverter.
Setting:
Acceleration (Clockwise)
output frequency is changed after a start, stop or brake command or when the reference value is
changed.
Setting:
Operation Mode
cording to the connected signal source.
Setting:
Fixed Frequency 1
cies is effected via the fixed frequency change over function of the multi-function input MFI1
Operation Mode
S5IND, the fixed frequency in one of the four data sets can be selected.
Up to 8 fixed frequencies can be parameterized and selected via the control of the digital inputs.
Setting:
Op. Mode Digital Output 1
functions can be assigned to the digital output S1OUT and the relay output S3OUT.
Setting:
06/07
06/07
372 – Enter the motor speed (at rated frequency) indicated on the type plate of the
-1 -1
96 min ... 60000 min
374 – Enter the cos (ϕ) value indicated on the type plate of the asynchronous
0.01 ... 1.00
375 – Enter the rated frequency (at parameterized rated speed) indicated on
10.00 ... 1000.00
376 - Enter the power (in kW) indicated on the type plate of the asynchro-
0.1⋅P ... 10⋅P
FIN FIN
400 - The factory setting of the switching frequency is dependent on the
2 kHz, 4 kHz, 8 kHz, 12 kHz, 16 kHz
401 – defines the minimum value the switching frequency is reduced
2 kHz, 4 kHz, 8 kHz, 12 kHz, 16 kHz
418 - the start command entered via the control unit or digital inputs
0.00 Hz ... 999.99 Hz
419 - The speed range of the drive is limited by the maximum output fre-
0.00 Hz ... 999.99 Hz
Deceleration (Clockwise)
420,
0.00 Hz/s ... 9999.99 Hz/s
452 (for multi-function input); the set point at input MFI1 can be adjusted ac-
1 - voltage signal, 0 V ... 10 V (factory setting)
2 - current signal, 0 mA ... 20 mA
3 - digital fixed frequency change-over, 0 V ... 24 V, digital input
Fixed Frequency 2
480,
452 (multi-function input on setting 3). Via the data set change-over S4IND,
-999.99 Hz ... 999.99 Hz
Op. Mode Digital Output 3
530,
0 - switched off
2 - run signal, drive turning/not turning message
3 - fault message
11 - Warning
41 - trigger electro-mechanical brake
1xx - inverted operation mode (LOW active)
421 - the ramps define how fast the
481 - change-over between the two fixed frequen-
532 - various control and monitoring
31
31