Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Inputs
Line:
Mic:
Phono:
Outputs
Line:
Headphone:
Distortion:
Signal to Noise Ratio (maximum output) JIS-A weighted
Line:
Mic:
Phono:
Frequency Response
Line:
Mic:
Phono:
Channel Equalizer
Bass:
Middle:
Treble:
Channel Kill:
Power Consumption
Dimensions
Weight
Sampler
For the most effective wheel performance, occasional calibration is recommended:
1.
Select the Scratch effect.
2.
Move the WET/DRY (FX Mix Control) fader throughout its entire range.
3.
Spin the wheel while holding the Record (FX Controls) and Single Play (">" FX
Controls) buttons at the same time.
4.
The display will show "CAL".
SPECIFICATIONS
10Kohm input impedance
83mV rms sensitivity for 1.22V output
600 ohm input impedance unbalanced
1.9mv rms sensitivity for 1.22V output
200mV rms max input
47Kohm input impedance
1.3mV rms sensitivity @1KHz for 1.22V output
6.5V rms max
0.5W into 47 ohm
less than 0.01%
Better than 82dB
Better than 80dB
Better than 72dB
20Hz-20KHz
±0.5dB
20Hz-15KHz
±0.5dB
±1dB except for controlled attenuation of –3dB
@ 20Hz to reduce rumble and feedback
+6/-32dB @40Hz
+6/-32dB @1.35KHz
+6/-32dB @15KH
80dB at 20Hz to 20KHz
24 Watts typical
29 Watts with full headphone output
320mm(W)x355mm(D)x100mm(H)
6.1 kgs
The maximum sample length is 36 seconds, total available buffer is 48
seconds, and buffer not used for sampler is used for echo, delay, scratch,
reverse, and bleep effects. The sampler will automatically stop recording
once the record time exceeds 36 seconds.
10
Tabla de contenido
