Before First Use - Klarstein 10028328 Manual De Instrucciones

Drain Excess Water
If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly into the sink. It
will be necessary to drain excess water from hoses into a bowl or suitable container that is held outside and
lower than the sink.
Extension Hose
If you need a drain hose extension, observe to use a similar drain hose. It must be no longer than 4 metres;
otherwise the cleaning effect of the dishwasher could be reduced.
Water Softener
• The water softener must be set manually, using the water hardness dial.
• The water softener is designed to remove minerals and salts from the water, which would have a detrimental
or adverse effect on the operation of the appliance.
• The higher the content of these minerals and salts, the harder your water is.
• The softener should be adjusted according to the hardness of the water in your area. Your local Water Autho-
rity can advise you on the hardness of the water in your area.
Adjusting Salt Consumption
1. Open the door ,Switch on the appliance;
2. Press the Program button for more than 5 seconds to start the water softener set model wit hin 60 seconds
after the appliance was switched on( The Salt and Rinse aid warning lights will be on periodically when it get
in the set model );
3. Press the Program button to select the proper set accor ding to your local environment, the sets will change
in the following sequence: H1->H2->H3->H4->H5-> H6;
4. Press the Power button to end the set up model.
°dH
0-5
6-11
12-17
18-22
23-34
35-55
1°dH = 1.25°Clarke = 1.78°fH = 0.178 mmol/l
dH = German degree / fH = French degree / Clark = British degree
Manufactory setting: H4 (EN 50242)
27

Before first Use

Water hardness
°fH °Clarke
0-9 0-6
10-20 7-14
21-30 15-21
31-40 22-28
41-60 29-42
61-98 43-69
Selector position
mmol/l
0-0.9 H1
1.0-2.0 H2
2.1-3.0 H3
3.1-4.0 H4
4.1-6.1 H5
6.2-9.8 H6
Salt consumtion
g/cycle
0
9
12
20
30
60