Technical Specifications - Perel WAF18M4 Manual Del Usuario

The device is not working at all
Possible causes:

The power cord is not plugged in.

The on/off switch is in the OFF position.
Solution: plug the power cord into a suitable mains outlet and set the on/off switch in the ON position.
Low suction
Possible causes:

The container is full.

The filter or filter enclosure are not properly installed, or dirty.

The hose, hose connection, air outlet, etc. are jammed.
Solution: clean the device as described in Chapter 6. Cleaning. Make sure that filter and filter enclosure
are properly installed.
8.

Technical Specifications

power supply
rated power
volume
suction
cable length
hose length
comes with
replacement HEPA filter (not incl.)
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulting from (incorrect) use of this device.
For more info concerning this product and the latest version of this manual, please visit our
website www.perel.eu.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part
of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 02 – 01/04/2014
WAF18M4
230 Vac 50 Hz
800 W
18 L
16 kPa
1.5 m
0.8 m + aluminium extension pipe
1 HEPA filter
order code WAF18M4FIL
7 ©Velleman nv