Maintenance; Problems - Causes - Solutions; Instructions For Dismantlement And Discarging - Volpi V BLACK PROTON Manual De Uso

6

MAINTENANCE

6.1 INTRODUCTION
A correct use of the sprayer and a regular maintenance are necessary to keep the sprayer in the best working, efficacy and
safety conditions.
Use exclusively original spare-parts.
6.2 BATTERY RECHARGE
The sprayer is powered by a battery, rechargeable through USB cable connected to the Micro USB port placed on the head of
the sprayer (fig. 9).
The Micro USB port is secured by a proper cover.
WARNING: During the recharge operations, follow safe working procedures and carefully observe the general safety rules.
In order to recharge the battery, follow these instructions:
•
Turn off the general switch
•
Open the cover of the Micro USB port.
•
Connect the USB cable S of the power supply R to the Micro USB port placed at the head of the sprayer.
•
Once the recharge process has started all the led lights flash sequentially. When the 3 led are all turned on, the recharge
is almost complete.
•
To recharge the battery completely, you need 4,5-5 hours.
•
Once the recharge is completed, place the cover on the Micro USB port again.
•
During long periods of inactivity, check that the general switch is off.
The battery life mostly depends on the observance of some important rules:
•
Do not create a short-circuit.
•
Promptly recharge it with the general on/off switch turned off and respecting the necessary time of charging.
•
Do not turn on the sprayer during the charging phases.
•
Always store the sprayer with the general switch off.
•
After the complete recharge keep the sprayer between 5 and 40° C.
•
In case of long stocking or non-use, recharge the battery every four months.
7 PROBLEMS – CAUSES – SOLUTIONS
When turning on the switch of
the sprayer, no water is coming
out
When turning on the switch of
the sprayer, a little water is
coming out.
Battery working time is not as
expected
8 INSTRUCTIONS FOR DISMANTLEMENT AND DISPOSAL
To dismantle the sprayer, it is necessary to operate according to laws in force, contacting, if necessary, specialized companies
in materials disposal.
The sprayer is made of non-dangerous materials:
•
Plastic and synthetic materials;
•
Iron metals (steel) and non-iron metals (aluminium-brass-copper);
•
Li-ion battery
____________________________________________________________________________________________________________________________________________________________________________________________________________
DAVIDE E LUIGI VOLPI S.p.A. - Via San Rocco,10 - 46040 CASALROMANO (MN) - ITALY
Davide e Luigi Volpi S.p.A.
Via San Rocco,10 – 46040 Casalromano (MN) – Italy
Tel. +39 0376.76009 - 76012 Fax. +39 0376.76408
E-mail: [email protected]
PROBLEMS
Motor does not work
Motor works
Lower working time
No endurance
www.volpioriginale.it
– [email protected]
POSSIBLE CAUSES
Low battery
Blocked sprayer
Broken cable
Engine failure
Clogged nozzle
Clogged handle filter
Defective sprayer
Defective sprayer
Dirty nozzle
Battery not fully charged
Broken cable
YLB19SME_0 Libretto d'uso V_BLACK PROTON
SOLUTIONS
Recharge
Contact the service centre
Contact the service centre
Contact the service centre
Clean
Clean
Contact the service centre
Contact the service centre
Clean
Recharge the battery
Contact the service centre
pag. 15 di 28