Relay Mode Installation; Introduction; Mounting; Mounting Considerations - RISCO Group WatchOUT PIR Instrucciones De Instalación

Introduction

RISCO Group's PIR Outdoor detector, WatchOUT, is a unique detector with signal processing
based on two Passive Infrared (PIR) correlated channels. The detector can operate as a regular
relay detector connected to any control panel, or as a BUS accessory when connected to RISCO
Group's ProSYS control panel via the RS485 BUS, thus having unique remote control and
diagnostic capabilities.
The following instructions describe the installation of the WatchOUT in Relay & BUS mode.

Mounting

Mounting Considerations

Optional Height: 1m – 2.7m
(3'3"-8'9")
Typical Height: 2.2m (7'2")
Default Lens: Wide angle 12m (40') 90°
(RL300)
Note:
1. For low installations, below 1.7m (5'6") in which
pet immunity is required, use the supplied
RL300F lens (Low wall or fence installations).
2. The detector's pet immunity (height of an animal,
no weight limitation), is up to 70 cm (2'4"), when
installing the detector at 2.2m (7'2"). If the
installation is bellow the height mentioned
above, the Pet Immunity decreases accordingly;
every 10 cm (4") decrease in installation height
leads to 10 cm (4") decrease in pet imunity.
For installations with extensive vehicle traffic or targets
beyond the required detection range, it is recommended to
tilt the detector down.
Note:
Tilting the detector down may reduce the pet immunity
For optimum detection, select a location
that is likely to intercept an intruder moving
across the coverage pattern at a 45°
trajectory.
4

Relay Mode Installation

1m - 2.7m
(3'3" - 8'9")
If possible, avoid pointing the detector to
moving objects (swaying trees, bushes
etc.)
Ensure any objects do not obstruct the
field of view. Pay attention to growing trees
or bushes, plants with big moving leaves
etc.
WatchOUT PIR Installation Manual
5m (16')
With moving objects
keep distance of
minimum 5 meters (16')
Out of
Detection Range