Idiomas disponibles
Idiomas disponibles
erase memory transmitters
•
GB
delete
menu
and press ENTER. The message
cancel all the recorded codes is confi rmed by pressing ENTER or the operation is
cancelled by keeping the same key pressed for longer.
N.B: To cancel the memory of the receiver, it is neccessary to confi rm twice the
cancellation (
Language
The display is available in two languages:
To select the chosen language go to the menu
italiano
Learning
This operation allows the automation to automatically establish the start and end
of a stroke identifying the respective mechanical strokes. Before proceeding with
this operation, ensure that the gate has been installed correctly and fi rmly and
that the en function of the control board has been activated (Stagnoli supplies the
control board with this function already activated).
When the wording
motors will close the gate. They will open it completely again and will repeat
this operation once more with the control board display showing maximum use of
the motors. Then set the regulation values fm1a and fm1c so that they exceed
the detected values (if
greater anti-crushing sensitivity).
Should consumption be shown to be excessively high, check that there are no
areas where the gate has greater friction. To do this, monitor the values showing
instant absorbed power by the motors during their stroke and presented in the
second main screen of the display. If the operation has been carried out correctly,
the message
ERR
will appear.
WARNING: during learning manoeuvres, the control board will ignore START and
PEDESTRIAN commands and will work with the force parameters that have been
set. Even if the safeties remain active, ensure that there are no objects or people
in the area of operation of the gate.
Read code
It is possible to check if a code has already been memorised. Position yourself on
the wording
(PRESS)
describing the code will be viewed:
•fi rst screen:
The fi rst letter indicates the manufacturer of the radio control, where
Stagnoli and
The second letter indicates the type of code, where
f
a fi xed code.
The last two indicate the code of the key that was pressed.
•second screen:
that follows (progressive from 0 to 75), indicates the position occupied by the
29
, then go to the wording
erase memory transmitters
english
or
and confi rm by pressing ENTER.
setup
fm1a
OK
will appear. If this has not been carried out correctly, the message
read code
, press ENTER, the display will show the message
.
Now press the transmitter key that must be checked, a series of screens
S r 01
- f 01.
or
-
a generic manufacturer.
P_00
, where
= to cancel all the recorded transmitters, enter the
erase memory transmitters
PRG
will appear, it fl ashes until the decision to
and
italiano
appears on the display, press ENTER. At this point the
fm1c
fm2a
fm2c
,
,
and
P
indicates the word "position" and the number
PRG
)
english
and
.
language
and press ENTER. Go to
have a low value this indicates
r
indicates a rolling code and
on the display
PREMI
S
means
