Sanus VLT16 Manual De Instrucciones página 11

3. Remove the wall plate
14
IMPORTANT: Be sure to drill into the center of the stud.
IMPORTANT: Pilot holes must be drilled to a depth of 75 mm (3 in.), using a 5.5 mm (7/32 in.) diameter drill bit.
4. Install wall plate using lag bolts
14
CAUTION:
Improper use could reduce the holding power of the lag bolt. DO NOT over-tighten the lag bolts.
3
and drill pilot holes.
and washers
15 17
75 mm
(3 in.)
5.5 mm
(7/32 in.)
. Tighten the lag bolts only until the washers are pulled firmly against the wall plate.
4
14
17
15
11