Important Safety Instructions; Basic Setup - Fellowes Powershred 99Ci Manual De Instrucciones

Ocultar thumbs Ver también para Powershred 99Ci:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
A.
B.
C.
D.
E.
F.
CAPABILITIES
Will shred: Paper, plastic credit cards, CD/DVDs, staples, small paper clips and junk mail
Will not shred: Adhesive labels, continuous form paper, transparencies, newspaper,
cardboard, large paper clips, laminates, file folders, X-rays or plastic other than noted above
Paper shred size:
Cross-Cut ........................................................................................................... 4 x 38mm
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
manual. Read the entire instruction manual before operating shredders.
to off or unplug when not in use.
openings. If object enters top opening, switch to Reverse (
shredder. DO NOT USE "CANNED AIR" OR "AIR DUSTERS" ON SHREDDER. Vapors
from propellants and petroleum based lubricants may combust causing serious
injury.
Do not place near or over heat source or water.
BASIC SET UP
CASTER INSTALLATION
1
2
G.
H.
KEY
A. SafeSense
B. Paper entry
C. See safety instructions
D. CD/Card safety flap
E. Pullout bin
F. Casters
G. Disconnect power switch
2
3
H. Control Panel and LEDs
Technology
®
1. Overheat (red)
2. Bin open (red)
3. Bin full (red)
4. Remove Paper (red)
5. SafeSense
1. OFF
2. ON
Maximum:
Sheets per pass ........................................................................................................... 18*
CDs/Cards per pass ....................................................................................................... 1*
Paper entry width .................................................................................................. 230mm
* A4 (70g), paper at 220-240V/50/60 Hz, 2.5Amps; heavier paper, humidity or other than rated voltage
may reduce capacity. Maximum recommended daily usage rates: 1500 sheets per day, 50 credit cards;
10 CDs.
18 sheets per pass.
Fellowes SafeSense
®
shredders are designed to be operated in home and office environments ranging
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
position to operate shredder. In case of emergency, move switch to OFF ( )
position. This action will stop shredder immediately.
) to back out object.
voltage and amperage designated on the label. The grounded outlet or socket
transformers, or extension cords should not be used with this product.
4
6. Reverse
7. ON/OFF (blue)
8. Forward
indicator (yellow)
®
5
ENGLISH
Model 99Ci
( )
Tabla de contenido
loading

Tabla de contenido