Fein FMM250Q Manual De Instrucciones página 15

3 41 01 078 06 0.book Seite 14 Dienstag, 16. März 2010 7:39 07
en
14
The sanding sheet can be pulled off again and then
remounted offset by 120° when only one tip of the sand-
ing sheet is worn.
Securing the work piece.
Secure the workpiece firmly. A work piece that is
gripped tightly in a clamping device or vice, is more
secure than if held by hand.
General operating instructions.
Switching ON and OFF.
First check that the mains supply lead and mains
plug are not damaged.
Switching ON:
Push the switch (2) towards the front (I).
Switching OFF:
Push the switch (2) toward the rear ( ).
Presetting the oscillating frequency (Figure 3).
The oscillating frequency can be pre-selected infinitely
variable.
Increasing the oscillating frequency:
Turn thumbwheel (3) in anticlockwise direction.
Decreasing the oscillating frequency:
Turn thumbwheel (3) in clockwise direction.
The oscillating frequency depends on the application and
the application tool. Example:
– High oscillating frequency:
Sanding, sawing, using as a rasp, polishing stone and
metal.
– Low oscillating frequency:
Polishing of varnish and veneers.
Working instructions.
Sanding
Typical application: Dry sanding of wood and metal,
especially of smaller surfaces, corners and edges, as well
as hard to reach locations.
Work with the complete surface of the sanding plate, not
only with the tip. Select a high oscillating frequency. Sand
with continuous motion and light pressure. Applying
excessive pressure does not increase material removal;
only the sanding sheet wears more quickly.
Sawing
Typical application: Sawing of thin steel sheet, wood and
plastic components.
Select a high oscillating frequency. Round saw blades can
be loosened and attached offset, in order to provide for
uniform wear.
Scraping
Typical application: Scraping off old coats of varnish or
adhesives, removing bonded carpeting, e. g., on stairs/
steps or other small/medium-sized surfaces.
Select a medium to high oscillating frequency.
For further information as well as tips on polishing, cut-
ting, separating and using as a rasp, see the booklet "Ideas
for Usage".
Storage (M M FMM250Q).
ULTI ASTER
Fully insert the fastening element (6a) into the
tool holder in order to protect it against damage
and contamination.
Engage the quick-clamping lever.
Repair and customer service.
When working metal under extreme operat-
ing conditions, it is possible for conductive
dust to settle in the interior of the power
tool. The total insulation of the power tool can be
impaired. Blow out the interior of the power tool via the
ventilation slots frequently with dry and oil-free com-
pressed air, and connect a residual current device (RCD)
on the line side.
If the supply cord of this power tool is damaged it must
be replaced by a specially prepared cord available
through the FEIN customer service centre.
If required, you can change the following parts yourself:
– Application tools
– Fastening element (6a)
– Clamping screw (7b)
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer's warranty declaration.
The delivery scope of your power tool may include only
a part of the accessories described or shown in this
instruction manual.
Declaration of conformity.
FEIN declares itself solely responsible for this product
conforming with the relevant provisions given on the last
page of this Instruction Manual.