Genius Audio GHD 3000 Manual Del Usuario página 4

Input and power supply connections
CAUTION: All connections to power supply, input and output connectors must be
Congratulations, you have purchased a
carried out only with amplifier off.
It was developed in a modern laboratory and with the latest technology.
This manual covers all features, operations and instructions to solve any doubt that may arise
during the installation. Please take some time to read it carefully in order to ensure the proper
installation and the use of all benefits this product can offer.
For questions, please call +55 (507) 261.7256 / 6448 or visit www.geniuscaraudio.com.
CD/DVD Player
Mp3
00:0000
032
Key Recommendations
You can find below some key recommendations to get the most out of your
amplifier:
Examples of connections in the
1-) Read this instruction manual carefully before carrying out any connection.
power supply input:
ANY CONNECTION TO THE AMPLIFIER INPUT OR OUTPUT MUST BE
Note: Minimum current required: 170A
CARRIED OUT WHEN AMPLIFIER IS OFF;
2-) Check carefully the polarity of power supply wiring (battery's positive and
It is compulsory to install
negative terminals) and loudspeakers, and the minimum speaker impedance;
protection fuses or circuit
3-) It is compulsory to install fuses to protect against overloading. The fuse or
breakers the closest possible
from batteries, and the final value
circuit breaker must be installed as close as possible to the battery and sized
should be around 170A
according to the amplifier;
4-) The gauge of power supply wiring is extremely important both to reach the
desired amplifier output and to the amplifier's safety. Use the wire gauge
recommended in this manual (page 5). Using wire gauges below the specified
value will result in power loss and overheating of cables. It is important that the
power supply cables are the shortest possible.
5-) Amplifier must be installed in a firm and ventilated area.
6-) In order to avoid interferences, the signal cable (RCA) must be away from
the original wiring of vehicle or from any other power supply cable.
Remoto
7-) The amplifier must be installed by a qualified professional.
Recommended wire gauge and fuse
Positive / negative power supply cable
Protection fuse or circuit breaker
Calculated considering a maximum length of 4 m.
Caution:
Using wire gauges below the recommendation will result in power loss and overheating of wiring.
Check polarity and never reverse power supply cables due to the risk of damage to the amplifier.
1 5
6
Genius Audio product.
RCA Cable
21mm² (4 AWG)
21mm² (4 AWG)
21mm² (4 AWG)
GHD 3000 - MONOBLOCK AMPLIFIER
Examples of output connections
Technical features
Caution: Observe the minimum impedance when installing, since impedances lower
than the recommended can damage the amplifier and void the warranty.
EXAMPLES OF CONNECTIONS
MODEL
NUMBER OF CHANNELS:
MAXIMUM OUTPUT POWER @ 13.8VDC - 1 OHM:
MAXIMUM OUTPUT POWER @ 13.8VDC - 2 OHMS:
MAXIMUM OUTPUT POWER @ 13.8VDC - 4 OHMS:
MAXIMUM OUTPUT POWER @ 13.8VDC - 8 OHMS:
MAXIMUM OUTPUT POWER @ 12.6VDC - 1 OHM:
MAXIMUM OUTPUT POWER @ 12.6VDC - 2 OHMS:
MAXIMUM OUTPUT POWER @ 12.6VDC - 4 OHMS:
MAXIMUM OUTPUT POWER @ 12.6VDC - 8 OHMS:
INPUT SENSITIVITY:
TOTAL HARMONIC DISTORTION (THD):
SIGNAL-TO-NOISE RATIO:
FREQUENCY RESPONSE:
CROSSOVER:
H.P.F (HIGH-PASS FILTER):
L.P.F (LOW-PASS FILTER):
BASS BOOST:
EFFICIENCY:
INPUT IMPEDANCE:
PROTECTION SYSTEM:
MINIMUM SUPPLY VOLTAGE:
MAXIMUM SUPPLY VOLTAGE:
IDLE CONSUMPTION:
170A
MAXIMUM MUSICAL CONSUMPTION @ 12.6VDC:
MAXIMUM CONSUMPTION IN SINUSOIDAL SIGNAL (1 KHz) @ 12.6VDC:
DIMENSIONS (WxHxD):
WEIGHT:
*Output cables with 4mm² (11 AWG) gauge, calculated considering a maximum length of 2m (78,74").
www.geniuscaraudio.com
- 1 OHM MODE L
GHD 3000
1 OHM
1
3598W RMS
2446W RMS
2 ohms 2 ohms
1403W RMS
_
3000W RMS
2040W RMS
1170W RMS
_
250mV @ (-9.78 dBm)
0.3%
>95dB
10Hz to 15KHz
10Hz to 50Hz(-12dB/Octave) Variable
50Hz to 15KHz(-12dB/Octave) Variable
0 to 10dB (50Hz)
73%
18K OHMS
Short-Circuit to Output/High/Low supply voltage
4 ohms 4 ohms
9VDC
16VDC
1.70A
170A
340A
229 x 65 x 288mm (9" x 2.56" x 11.34")
4 ohms 4 ohms
3.11Kg ( 6.86lb)
7
6 2