ReddyHeater IWH16NLTD Manual De Instalación Y Funcionamiento Del Propietario página 12

Installing Bottom Mounting Bracket
1. Install bottom bracket to heater bottom
with two screws. It may be more conve-
nient to remove heater from wall bracket
to attach.
2. Place heater on wall mounting bracket.
3. Mark screw locations on wall.
4. Remove heater from mounting bracket.
5. If installing bottom mounting screws into hol-
low or solid wall, install wall anchors. Follow
steps 1 through 4 under Attaching To Wall
Anchor Method, page 11. If installing bottom
mounting screw into wall stud, drill holes at
marked locations using 9/64" drill bit.
6. Replace heater onto mounting bracket.
7. Place spacers between bottom mounting
holes and wall anchor or drilled hole.
8. Hold spacer in place with one hand. With
other hand, insert mounting screw though
bottom mounting hole and spacer. Place
tip of screw in opening of wall anchor or
drilled hole.
9. Tighten both screws until heater is firmly
secured to wall. Do not over tighten.
Note: Do not replace front panel at this time.
Replace front panel after making gas connec-
tions and checking for leaks.
Before installing heater to base, please make
sure you have a hardware packet that con-
tains the following items:
2 - Base Feet
4 - Sheet Metal Screws
1. Carefully lay heater on its back on a table
with the bottom of the heater extending
outside the table edge.
2. Attach base feet to heater using sheet
metal screws.
12
INSTALLATION
Front View
10,000 Btu
INSTALLATION OF BASE STAND
(If Equipped)
www.sureheat.com
Front View
Front View
10,000 Btu
20,000 Btu or 30,000 Btu
Heater
Side View
Side View
Figure 11 - Installing Bottom Mounting
Screws
Base Feet
Sheet Metal Screws
Figure 12 - Installing Base Feet
Front View
20,000 Btu or 30,000 Btu
Wall
Spacer
200216-01A