Flotec E3305TLT Manual De Instalación Y Operario página 5

Installation
Installation
1. Install the pump in a sump pit with a minimum
diameter of 14" (356mm). The sump depth should be
15" minimum (381mm). Construct the sump pit of
tile, concrete, steel or plastic. Check local codes for
approved materials.
2. The pump should not be installed on clay, earth or
sand surfaces. Clean the sump pit of small stones
and gravel which could clog the pump. Keep the
pump inlet screen clear.
3. Install the pump in the pit so that the
switch operating mechanism has maximum
possible clearance. Do not lift the pump by the
power cord. See the Cord Lift Warning.
4. Install the discharge plumbing. When using rigid
pipe, use plastic pipe. Wrap the threads with PTFE
pipe thread sealant tape. Screw the pipe into the
pump hand tight +1 – 1-1/2 turns.
NOTICE: Do not use ordinary pipe joint compound
on plastic pipe. Pipe joint compound can
attack plastics.
Risk of flooding . If a flexible discharge
hose is used, make sure the pump is secure in
the sump to prevent movement. Failure to secure
the pump may allow pump movement, switch
interference and prevent the pump from starting
or stopping.
5. To reduce motor noise and vibrations, a short length
of rubber hose (e.g. radiator hose) can be connected
into the discharge line near the pump using
suitable clamps.
WARNING
Risk of electrical shock .
Can burn or kill .
Do not lift pump by power
cord .
For parts or assistance, call Flotec Customer Service at 1-800-365-6832
6. Install an in-line check valve to prevent backward
flow through the pump when the pump shuts off.
7. Power Supply: The pump is designed for 115 V .,
60 Hz ., operation and requires a minimum
15 or 20 amp individual branch circuit (refer to
Specifications.) Both the pump and switch are
supplied with 3-wire cord sets with grounding-type
plugs. The switch plug is inserted directly into the
outlet and the pump plug inserts into the opposite
end of the switch plug.
or kill. The pump should always be electrically
grounded to a suitable electrical ground such as a
grounded water pipe or a properly grounded metallic
raceway, or ground wire system. Do not modify the
cord or plug or cut off the round ground pin .
8. If the pump discharge line is exposed to an outside
sub-freezing atmosphere, the portion of the line
exposed must be installed so any water remaining in
the pipe will drain to the outfall by gravity. Failure to
do this can cause the water trapped in the discharge
to freeze which could result in damage to the pump.
9. After the piping and check valve have been installed,
the unit is ready for operation.
10. Check the operation by filling the sump with
water and observing pump operation through one
complete cycle.
operational check may lead to improper operation,
premature failure, and flooding.
Cord Lift Warning
Hazardous voltage . Can shock, burn
Risk of flooding . Failure to make this
Risk of electrical shock and fire .
1. Attempting to lift or support the pump by
the power cord can damage cord and cord
connections, expose bare wires, and cause a fire or
electrical shock.
2. Use lifting ring or handle on top of pump for
all lifting or lowering of pump. Disconnect the
power to the pump before doing any work on it or
attempting to remove it from the pit.
3. Lifting or supporting the pump by the power cord
will void the warranty.
5