Troubleshooting - Pihernz RANGE EXTENDER ATX-3000A Manual De Instrucciones

10.- TROUBLESHOOTING:

If you have problems with the ATX-3000A, follow the instructions in the table below.
Problem
No turn ON
ATX-3000A.
TX and RX error.
Low battery charge.
The battery
discharged quickly
after its full charge.
No response the
ATX-3000A.
No response.
The DTMF remote
control does not
work.
The DTMF keypad
does not work.
The communication
coverage range is too
short.
If it continues the problems, consult with their distributor, salesperson or Technical Service.
the Check that the external supply voltage is within a voltage range of 5 VDC
to 24 VDC.
Make sure that the external power supply voltage is stable and that the
ATX-3000A is turned ON.
If the supply voltage is correct, the equipment may be damaged.
The transceiver get more noise:
Set "CTCSS" tones or "DCS" codes for repeater operation.
The transceiver get noise after setting "CTCSS"/"DCS":
Set the squelch level of the transceiver that is connected to the ATX-
3000A.
The AC/DC power supply (optional) or the internal battery maybe
damages, replace the AC/DC power supply or battery with one of the
same characteristics as the one supplied with the unit.
is The battery life has finished, replace it with a new one of the same
characteristics as the one supplied with the equipment.
There is a problem with the transceiver or the volume of the transceiver is
set too low.
If the transceiver does not receive, select another channel or check that
the programmed "CTCSS" tones or "DCS" codes are the same on all
transceivers in the user group.
The transceiver does not incorporate the DTMF function.
The setting audio level is too low or too high.
The audio level is too low or too high. Check the DTMF keypad.
The transmitter power of the transceiver is too low, select the high power
or use a transceiver with higher transmission power.
Possible solution
English - 14 -
RANGE EXTENDER