Nolan N902 Seguridad E Instrucciones página 16

Checking and Adjusting the PINLOCK
Check the correct PINLOCK
and make sure that they do not move. If the PINLOCK
fixed to the visor, move gradually both external adjustment levers upwards to stretch
(Fig.8). The maximum stretch is achieved when the pin adjustment external levers are
turned outwards.
WARNING
- The presence of dust between the two visors may scratch both surfaces.
- Scratched PINLOCK
therefore be replaced.
- Regularly check the correct stretch of the PINLOCK
moving and scratching both surfaces.
- If the helmet visor fogs up and/or condensation forms between the visors, check
that the PINLOCK
- An excessive and early stretch of the PINLOCK
ces-sive adherence against the visor surface and/or permanent deformations
with subsequent inability to correctly perform any following adjustments.
- Intense sweating/breathing, the use under particular weather conditions - low
temperatures, high humidity, sudden changes in temperature, heavy rain - or
wear may affect the performance of the PINLOCK
or condensation. In such cases, remove the PINLOCK
met visor and let it dry with dry and warm air after use, to restore its performance.
The same procedure should be applied to the helmet in order to dry out humidity
in case it has formed up as a consequence of the conditions described above.
6. PINLOCK Inner Visor Disassembly
®
6.1. Remove the visor with PINLOCK
6.2. Widen the visor and release the PINLOCK
6.3. Release the visor.
Maintenance and Cleaning
- Remove the PINLOCK
gently clean it with neutral liquid soap. Remove the soap under running water.
- Dry the inner visor with dry and warm air without wiping it.
- Let the helmet dry in a ventilated and dry place with the visor open after use.
Keep it away from heat sources and store it in a place away from direct light. This
way inner visor will be kept in good conditions over time.
- Do not use solvents nor chemicals.
VISION PROTECTION SYSTEM (VPS)
The exclusive inner VISION PROTECTION SYSTEM (VPS) is a LEXAN™(*) poly-
car-bonate moulded sunscreen with scratch-resistant/fog-resistant treatment. It is
very simple and practical to use. Just lower to activate it or lift to remove it from the
field of vision. It is useful in all sorts of situations, both on long journeys out of town
and shorter town trips.
Moreover, the innovative fastening system allows you to assemble and disassemble
the sunscreen without the need for any tools for ordinary maintenance and cleaning
operations.
LEXAN is a trademark of SABIC.
(*)
inner visor assembly by opening and closing the visor
®
visors and inner visors may reduce visibility and should
®
inner visor is both correctly assembled and stretched.
®
inner visor as per instructions above.
®
inner visor from the visor. Using a damp and soft cloth,
®
Inner Visor Stretch
®
inner visor to prevent it from
®
inner visor may result in ex-
®
inner visor and cause fogging
®
inner visor from its pins (Fig.7).
®
16
inner visor is not tightly
®
inner visor from the hel-
®