Insert The Batteries - TFA 60.2560 Serie Instrucciones De Uso

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
TFA_No. 60.2560_Anleitung_
23.12.2020
TWIST – Radio-controlled alarm clock
Position alarm OFF
C 5:
LIGHT sensor button on the top
Position alarm ON
C 6:
SNOOZE/LIGHT sensor button on the top
D: Housing (Fig. 1+4):
D 1:
Light sensor
D 2:
Battery compartment
5. Getting started

5.1 Insert the batteries

• Remove the protective film from the display.
• Open the battery compartment and insert two new AA 1.5 V batteries, polarity as illustrated.
• The backlight turns on for a short period. All LCD segments will be displayed for a short
moment. Close the battery cover again.
34
17:11 Uhr
Seite 18
TWIST – Radio-controlled alarm clock
5.2 Radio-controlled time reception
• The clock will now scan the DCF frequency signal and the DCF symbol flashes on the display.
When the time code is successfully received after some minutes, the radio-controlled time and
the DCF symbol will be shown steadily on the display.
• If there is no reception, you can start the initialisation manually. Press and hold the MIN - and
the HR - button at the same time for three seconds.
• The DCF symbol flashes.
• Interrupt the reception by pressing again the MIN - and the HR - button at the same time for
three seconds. The DCF reception symbol disappears.
• The DCF reception always takes place daily at 2:00, 3:00 and 4:00 o'clock in the morning.
• There are three different reception states:
flashing – Reception is active
remains – Reception is successful
disappears – No reception
• If the clock cannot detect the DCF-signal (e.g. due to interference, transmitting distance, etc.),
the time can be set manually.
35
Tabla de contenido
loading

Tabla de contenido