Tabla de contenido
Idiomas disponibles
Idiomas disponibles
13. The bevel tool knob should be rotated only 1/4 turn per one revolution of
the cutter. The #4 14 Bevel Tool will produce a 15° bevel up to 5/8" long on
both sides of the cut.
14. Once the desired bevel is complete, continue feeding cut-off tool until pipe
is completely cut off. NOTE: Cutting and beveling plastic pipe can be done
simultaneously as long as the cut-off tool does not cut off the pipe before
the bevel is complete.
TO CHANGE CUT-OFF AND BEVEL TOOLS
Both cut-off and bevel tools can be replaced in the same manner: Rotate
feed knob clockwise until tool comes out of cutter. Reverse the procedure to
replace the tool. Ensure that the tools face the proper direction, cutting in the
same direction as the arrows on the cast frame.
Dull cut-off tools, if not chipped or broken, can be sharpened by any machine
shop that has silicon carbide or diamond wheels. Ordinary grinding wheels will
not effectively grind carbide. The bevel tool, made of hardened tool steel, can
be sharpened with conventional grinding equipment.
LUBRICATION
No lubrication is needed and the cutter parts should not be oiled. Dry graphite
occasionally applied to the moving parts will assure long life and easy opera-
tion.
SAFETY PROCEDURES
• OPERATE TOOL UNDER OSHA AND OTHER APPLICABLE SAFETY STAN-
DARDS.
Figure 5
Catalog No.
Item Code
Nº de catálogo
Código de artículo
PLAS0H
04463
PLAS0HPE
04464
PLASOH12PE
04468
PLAS0H12
04469
4
Pipe Capacity
Capacidad de tubo
Inches - Nominal
Pulgadas - nominales
4 - 8 minimum 4.2" actual O.D.
4 - 8 mínimo: 4.5" de diámetro exterior real.
4 - 8 minimum 4.2" actual O.D.
4 - 8 mínimo: 4.5" de diámetro exterior real.
4 - 12
4 - 12
Weight
Peso
Actual Ø mm
lbs
Ø mm reales
libras
106 - 240
21
106 - 240
21
106 - 335
52
106 - 335
52
Sections Used
Secciones utilizadas
kg
kg
9.6
E (2)
9.6
E (2)
23.6
E (2), B (1)
23.6
E (2), B (1)
Tabla de contenido
