GROLAB GRONODE HW03 Manual De Instalación página 17

MAINTENANCE
R Reset Network
With the module powered on, press and hold With the module powered on, press and hold
the module's reset bu on (3) and the the module's reset bu on (3) and the
network reset bu on (7), then release the network reset bu on (7), then release the
reset bu on (3) while holding the network reset bu on (3) while holding the network
reset bu on (7). The module should start reset bu on (7). The module should start
normally and a er some seconds you should normally and a er some seconds you should
see the ligh ng state indicator (9) to blink in see the ligh ng state indicator (9) to blink in
purple, you should now release the network purple, you should now release the network
reset bu on (7). r
A er A er rese ng rese ng
GroNode will return to the default network GroNode will return to the default network
se ngs. The default se ngs can be found on se ngs. The default se ngs can be found on
t the back of the module.
NOTE: DHCP op on is enabled by default, this way if the
GroNode is connected to a router that also has the
DHCP enabled, a new IP will be automa cally assigned
by the router.
the the network network
5
EN
ES
FR
se ngs, se ngs,
16