RedHotDot HOT INDUCTION HEATER Manual Del Usuario página 24

HOT INDUCTION
EN
HEATER
the part off. Be careful not to burn the paint! If sufficiently heated, the stripes should come off easily
and all the glue should be removed with the stripe.
Body side molding removal: body side moldings are removed in much the same way as decals and
graphics. However, with thick moldings, a greater heating power or time is required since the metal
underneath the molding is further away from the pad. Keep the pad parallel to the work surface for
better heat distribution. Also, instead of a circular motion, use a back and forward motion along the
length of the molding. Start at one end of the molding and work the pad slowly back and forward a
few inches until you can easily pry the end of the molding loose. Then slowly move the pad down
the length of the molding while peeling the molding off. Try to practice on scrap moldings to
develop your technique as with any new hand tool. The tape and adhesive should come off with the
moldings. If glue or tape is left on the panel, then slow down your motion or increase the amount of
heat.
Warming cold body panels: during the winter or in cold climates, decals, graphics, or striping require
to be warmed in the shop for the adhesive to stick. With the pad on the HOT Induction Heater, you
can quickly heat just the body section that you are working on to apply these items. This will save
you time instead of waiting for the panel to warm up when using conventional methods.
Bolt inductor
The bolt inductor is used for intense heating of rusted or stuck parts such as nuts and bolts. When
using the Bolt induc- tor to loosen stuck nuts and bolts, it is OK to use full power to start with. Other
uses include caulking removal from truck beds and trunks of sedans, as well as soldering large
electrical connectors and metal forming.
Removing stuck or rusted bolts: the Bolt inductor is particularly useful in removing stuck or rusted
nuts and bolts. It is better than an oxy-acetylene torch in several ways:
1. It only heats the metal parts positioned within the gap and without flames that can set fire to the
many plastic parts in today's cars. Thus, reduced fire hazards.
2. Unlike the torch which tends to heat both the nut and the bolt, the bolt inductor can be applied to
the nut only, hea- ting it and making it expand more than the bolt and thus easier to break loose.
3. The bolt inductor plugs into the HOT Induction Heater, it is lightweight, portable, and ready for
instant use.
4. It is not necessary to heat fasteners to a red color. In most case, only mild heat is required to free
the seized fastener. Prolonged exposure of the bolt Inductor to extreme heat will shorten the life of
the inductor and could cause un-war- ranted damage.
Bending metallic parts : the bolt inductor can also be used to quickly bend small round or flat steel
stock for a lot of application.
24