Atlantic SOLCC2 Manual Del Producto página 4

Maintenance
Replacement LED Bulbs are available for SOL Spout Lights. To loosen and tighten the brass lens
ring on SOL Spout Lights, use the included key. Simply place the key in the slots on the brass lens
ring to loosen or tighten. Ensure that all components are installed correctly after servicing. Inspect
the silicone gaskets for defects and proper placement before re-assembling. Ensure that the lens
ring is tightly secured before submersing the fixture.
SOLCCSL2
HARDSCAPE LIGHTS - SOLCCH06 / SOLCCH12
Installation
Hardscape Wall Lights are designed to be installed
into walls and columns, just under the capstone.
The LED light strip and driver can be replaced
without removing the capstone. The cord between
the driver connection and the light is approximately
19' , enabling the driver to be left outside of the
column or wall for future access. When laying the base
course of stone, either notch the cord into the wall or
leave a notch slightly larger than ¾" to pass the cord
through. If multiple lights are going to be installed, the
notch will need to be slightly larger to accommodate
multiple cords. When installing the mounting bracket,
make sure to notch the stone for the ¼"cord. Test fit
the mounting bracket and cord, so that it does not
rock or put too much pressure on the cord. The
holes in the bracket are for glue points to hold
the capstone and bracket in place.
NOTE: Hardscape Lights are not submersible.
Maintenance
Replacement LED fixtures are available for
Hardscape Lights. Remove the screws on the
existing light, being careful not to let the light strip
fall, as this could break the plug connecting the
light to the cord. Lower the light and squeeze the
locking clip; this will allow the plug to be separated.
Plug in the new light, making sure the gasket has
not moved or shifted and that the notched edge
of the light strip is between the two ridges on the
cord gasket. Align the screw holes and hand
tighten the screws.
4
Driver
SOLCCH06: