EMKO ESM-3712-HCN Manual De Instrucciones página 11

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Buzzer Function Selection Parameter
Buzzer is active during this time
If buzzer function selection parameter value
observed. Buzzer stays active during this time. It can be adjusted from 1 to 99 minutes
When this parameter is 1, if decrement button is pressed,
condition buzzer is active till buzzer silence button is pressed.
Communication Mode Selection Parameter
Slave ID Parameter
Device communication address parameter (1 to 247).
Manual Alarm Output Active Parameters (Default=0) MODBUS ADDRESS=40027
Programming Section Accessing Password
It is used for accessing to the programming section. It can be adjusted from 0 to 9999. If it is
selected 0, password will not be asked
i
,
is selected "Cooling". If operation type is selected "Heating " ,skip to the
6.3 Modbus Adresses of Device Status Parameters (Read Input Register)
MODBUS ADRES:30001
MODBUS ADRES:30002
MODBUS ADRES:30003
A
MODBUS ADRES:30004
MODBUS ADRES:30005
Buzzer is inactive.
Buzzer is active if an alarm occurs.
Buzzer is active during sensor failures.
Buzzer is active during alarm or sensor failures.
PROKEY communication selected.
RS 485 communication selected.
( Default = 1 ) MODBUS ADDRESS=400
Manual Alarm output passive
Manual Alarm output active
,
,
,
Temperature Value
Led Status
Device Status : 0.bit Alarm Status
Output Status
Device Type and Device Version
( Default = 0 ) MODBUS ADDRESS:40023
( Default =
) MODBUS ADDRESS:40024
=0, this parameter can not be
( Default = 0 ) MODBUS ADDRESS:400
( Default = 0 ) MODBUS ADDRESS:400
.
and
Parameters are observed if Operation type
o
: 0.bit C Led,6.bit Compressor Led,
7.bit Alarm Led, 13.bit Program Led,
14.bit Set Led
2.bit Buzzer Status
3.bit Sensor Break Status
0.Bit Compressor Output,1.bit Alarm Output
is observed. In this
26
parameter.
25
28
11
Tabla de contenido
loading

Tabla de contenido