Battery Replacement - HYGIPLAS GG748 Manual De Instrucciones

Maximum/Minimum reading memory
1. Press the [MAX/MIN] button to display the maximum reading, and the "Max" icon will be flashing.
2. Press the button again will show the minimum reading and the "Min" icon will be flashing
3. Press the button once more to return to normal display
High/Low temperature alarm setting
1. Press [SET] and the high (HI) limit value will flash
2. Press [UP] or [DOWN] to set high limit. *
3. Press [SET] again and the low (LO) limit value will flash
4. Press [UP] or [DOWN] to set low limit. *
5. Press [SET] to finish setting
*During setting the limit value, holding down the [UP} or {DOWN] will increase/decrease the value
automatically. Press [ON/OFF] with turn the alarm off or on.
When the reading is out of set limit the alarm will be on for 10 seconds and off for 5 seconds.
Press any key to stop the alarm but the HI or LO icon still flashes until the reading is within the limit.

BATTERY REPLACEMENT

1. Open the battery cover on the back case
2. Replace the battery with the same type and close battery cover.
NOTE
1. Clean the probe after each measurement to avoid cross contamination
2. Reset reading memory to current value before taking maximum/minimum reading
3. Do not expose thermometer to temperatures over 50°C/122°F or use in ovens.
4. The thermometer cannot be switched off when the hold function is activated or the
maximum/minimum reading is being displayed.
SYMBOLS
Symbol
Low battery voltage
X
1) Sensor open circuit
LLLL
2) The reading is out of low range (-50 C)
1) Sensor short circuit
HHHH
2) The reading is out of high range (300 C)
Description Action required
Replace the batteries
1) Return the thermometer for repair
2) Keep the measurement above low
range
1) Return the thermometer for repair
2) Keep the measurement below high
range
3