Genio 050973 Manual De Instrucciones página 21

LEVER RESET PROCEDURE
LEVER RESET PROCEDURE
The reset procedure will be needed when sander
operates abnormally or after maintenance.
1. Switch off the power.
2. Press and hold down the "+" button. Then plug-in
the power cord.(Figura 1) Press the "—" button for 5
times(Figure 2)and the tool now enters the reset mode.
Ensure to release the lever(Figura 3) and "+" button.
3. Ensure to release the lever(Figura 3) and "+"
button. Wait for the LED flash "red"color two times
(Figure 4).
4. Press the speed lever firmly (Figure 5)and wait for the
LED flash "red" color quickly (Figure 6), then release
the speed lever immediately (Figure 7). Wait for the
red light goes out(Figura 8), the reset procedure is
finished.
Figure 1
Figura 2
Figura 3
Figura 4
Manual EN
Figura 5
Figura 6
Figura 7
Figura 8
21