Control Panel - Omni International Bead Ruptor 96 Manual Del Usuario

1.
2.
3.
• RUN Signal light (green) - lit when the Bead Ruptor 96 is running.
• TIME Signal light (yellow) - lit when the Bead Ruptor 96 timer selection is active.
• FREQUENCY Signal light (yellow) - lit when the Bead Ruptor 96 frequency selection is
active. Frequency is defined as number of wave cycles per second (1/s).
Measured in Hz.
• CONTROL KNOB (rotate / push) - rotate right (+) Or left (-) to change the Time
or Frequency setting values. Push the Control Knob to switch between Time and
Frequency settings.
• START/STOP button - press to start or stop the cycle.
WARNING: Only start the Bead Ruptor 96 with the lid in the closed position. The
display will read "LID" if the lid is open when attempting to start. Always start and
stop the Bead Ruptor 96 with the Start/Stop button.

Control Panel

RUN TIME FREQ
0.30
1. Run signal light
2. Time signal light
3. Display Screen
START
STOP
4. Frequency signal light
5. Control Knob
6. Start/Stop button
4.
5.
6.