Festool DX 93 E Manual De Instrucciones página 4

21 Check for misalignment or binding of
moving parts, breakage of parts, and any
other condition that may affect the tools
operation. If damaged, have the tool
serviced before using. Many accidents are
caused by poorly maintained tools.
22 Use only accessories
recommended by the manufacturer for
your model. Accessories that may be suitable
for one tool, may become hazardous when used
on another tool.
Service
23 Tool service must be performed only by
qualified repair personnel. Service or
maintenance performed by unqualified
personnel could result in a risk of injury.
24 When servicing a tool, use only identical
replacement parts. Follow instructions in
the Maintenance section of this manual. Use
of unauthorised parts or failure to follow
Maintenance instructions may create a risk of
electric shock or injury.
Technical data
Power consumption
No load speed
No. of strokes
Abrasive stroke
Weight
Safety UL 745, CSA C22.2 No. 745
The illustrations referred to can be found on a
fold-out page at the front of the operating
instructions.
Symbols
V Volts
A Amperes
Hz Hertz
W Watt
~ Alternating current
n No load speed
0
Class II Construction
rpm Revolutions per minute
spm strokes per minute
Ø Diameter
Intended use
The Deltex sander can be used to smooth wood,
plastics, metal, steel, composite materials,
paintlacquers, filler, stopper and similar
materials. Thanks to the triangular shape of
the sanding pad the machine is particularly
suitable for processing tricky corners, edges
and grooves.
If explosive or self-igniting dusts are produced
during the sanding of certain materials the
that are
150 W
5 000 - 9 500 rpm
10 000 - 19 000 spm
2.5 mm (0.1 in.)
1.5 kg (3.3 lbs.)
Various dust created by power
sanding, sawing, grinding, drilling and other
construction activities contains chemicals
known (to the State of California) to cause
cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
•lead from lead-based paints,
•crystalline silica from bricks and cement and
other masonry products, and
•arsenic and chromium from chemically-
treated lumber.
The risk from these exposures varies,
depending on how often you do this type of
work.
To reduce your exposure to these
chemicals: work in a well
ventilated area, and work with
approved safety equipment, such
as dust masks that are specially
designed to filter out microscopic
particles.
manufacturer's processing instructions must be
observed.
If the machine is used predominantly for processing metals the inside of the drive unit
may become very dirty. In such cases we
recommend the use of a powerful extractor, a
shortening of cleaning cycles and/or the
superposition of a fault current (FI) breaker.
The user is liable for damages and accidents
arising from incorrect usage.
Electrical connections and starting
The mains voltage must comply with the voltage
specified on the ratings plate!
Push the switch (1.3) forwards to start the
machine. A slight pressure on the rear of the
switch is enough to switch the machine off.
When cold the machine may take a few minutes
to reach maximum speed. This is due to its
construction and is not serious.
Electronics
When processing different surfaces it is
helpful to adjust the sanding speed to
ELECTRONIC
the respective material.
The figures on the speed regulator (1.1) roughly
correspond with the following idling speeds:
5