Celestron TRAVEL SCOPE 70 DX Guía De Instalación Rápida página 2

Q U I C K S E T U P G U I D E
E N G L I S H
#22035
1 1
Unpack your telescope and verify that all parts are present. Your
Travel Scope 70 DX includes: a telescope tube, a tripod and
mount head, two eyepieces, a 2x Barlow lens, a finderscope, an erect
image diagonal, a smartphone adapter, a Bluetooth shutter remote, a
Moon filter, a Robert Reeves' Lunar Landscapes book download card,
and a travel backpack.
4
To extend the tripod's central column, turn the locking knob
counterclockwise, lift up the tripod head until it is at the desired
height and turn the locking knob clockwise to secure.
7
Rotate the mounting platform so it is horizontal and tighten the knob
to secure it.
70 DX
2
To set up the tripod, spread the legs outward until they are fully
extended and push down on the center leg brace.
5
Loosen the knob on the side of the tripod head mounting platform
and rotate the platform 90 degrees so it is standing vertically.
8
Remove the cap from the focuser end of the telescope tube and
make sure the two thumbscrews do not protrude into the opening.
3
Extend the legs of the tripod by unlocking the three tripod lock levers
on each leg. Pull each leg section all the way out and push the lever
on each lock downward to secure it in place.
6
Match the threaded bolt in the mounting platform to the threaded
hole on the bottom of the telescope tube and thread the two together.
Do not overtighten. This should be snug, but not tight.
9
Locate the erect image diagonal and remove the plastic covers. Insert
the barrel of the diagonal into the focuser and secure in place by
tightening the set screws.
E NG LISH | 1