Device Delivery And Storage; Delivery; Device Identification; Damage During Transport - Gewiss JOINON Serie Manual De Instalacion Y Uso

Gewiss

4. Device delivery and storage

4.1. Delivery

Keep the device packaged until installation.

4.2. Device identification

The serial number of the device identifies it in an unequivocal manner.
The device serial number is also shown on the technical data plate on the lower part of the front panel.

4.3. Damage during transport

If the device was damaged during transport:
1. Do not install it.
2. Immediately notify the fact to your reseller within 5 days of device delivery.
If it is necessary to return the device to the manufacturer, the original packaging must be used.

4.4. Storage

Failure to observe the instructions provided in this section could cause damage to the device.
If the device is not installed immediately upon delivery, to avoid its deterioration, proceed as indicated below:
• To correctly conserve the charging station, do not remove the original packaging until the moment it is installed.
• Deterioration of the packaging (cuts, holes, etc.) prevents the correct conservation of the charging station prior to installation.
• Keep the device clean (remove dust, chips, grease, etc.) and avoid the presence of rodents.
• Protect it against water sprays, welding sparks, etc.
• Cover the device with a protective breathable material to avoid condensation caused by environmental humidity.
• Charging stations kept in a warehouse must not be subjected to climatic conditions other than those indicated below:
• It is very important to protect the system against corrosive chemical products and saline environments.
• Do not store the device where it is exposed to bad weather conditions.
48
Environmental conditions
Minimum storage temperature
Maximum storage temperature
Maximum relative humidity without condensation
Device delivery and storage
-40ºC
70ºC
95%
7.55.4.502.0 - Installation and Operation Manual