Function - Franke AQCT0073 Instrucciones De Montaje

12.10 Remove the shower panel.
12.11 Drill hole in accordance with the marking.
12.12 Insert the wall plug
☞
The battery compartment or power supply and extension cable are not part of the
scope of delivery (see Accessories,
☞
If you are using a wall-mounted power supply unit, it must be installed around 3 m
away from the shower.
12.13 Connect the AQUACONTACT sensor (f) with
– a battery compartment (d)
or
– a wall-mounted power supply unit (e).
☞
If the battery charge state is low, the LED flashes in a 20s cycle.
12.14 Only for water connection from the rear: Prioritise work steps 12.16 to 12.18.
12.15 Mount the shower panel on the suspension rail and screw tight.
12.16 Establish the water connections.
12.17 Open the water volume regulators using an Allen key.
g: closed
h: open
12.18 Check the water connections for leaks.

13. Function

☞
You can switch between time control and body reflection using the remote control
(not in the scope of delivery; see Accessories,
Time control
Trigger the flow of water
13.1 Hold your hand near the sensor.
• The water will flow.
• The water flow will stop automatically
– once the preset flow time expires
or
– after approaching the sensor once again.
☞
The flow duration is factory-set to 30 seconds.
Chapter
31).
Chapter
- 8 -
31)