Tabla de contenido
Tools/Outils/Herramientas
Siliconized Acrylic Caulk
Mastic à l'acrylique siliconée
2x6 Lumber or 3/4" Plywood Panel
Sellador acrílico siliconado
Planche de 2x6 ou panneau en contreplaqué de 3/4"
Postes de madera de 2x6 o panel de madera contrachapada de 3/4"
Before You Begin
CAUTION: Risk of property damage. Select the type of fastener based on the
wall material. Fasteners must have a minimum of 20 lb (9.07 kg) load bearing.
Install fasteners (not provided) through the vanity and into a header to avoid
possible property and product damage. If this is not possible, wall anchors (not
provided) must be inserted before installing the fasteners.
NOTICE: Siliconized acrylic caulk must be used to secure the lavatory to the vanity.
Do not use 100% silicone sealant, which will damage the finish of the vanity.
NOTICE: In order for the installation to be successful, the vanity must be level and
plumb. If necessary, rotate the levelers underneath the vanity feet.
NOTICE: This installation is easiest with two people.
Observe all local plumbing and building codes.
The appearance of your vanity may differ from the illustrations in this guide. The
instructions still apply.
Prior to installation, unpack the new product and inspect it for damage. Return
the product to its protective carton until you are ready to install it.
Select fasteners that are long enough to secure the vanity to the header. Take into
account the combined thickness of the back of the vanity and wall material.
Make sure the finished wall is straight and plumb, and the floor is flat and
perpendicular to the finished wall.
Remove any moldings that may inhibit the vanity from being flush against the
finished wall.
Kohler Co. reserves the right to make revisions in the design of products without
notice, as specified in the Price Book.
Avant de commencer
ATTENTION: Risque d'endommagement du matériel. Sélectionner le type de
fixation selon le matériau du mur. Les fixations doivent avoir une capacité de
support minimum de 20 lb (9,07 kg). Installer les fixations (non-fournies) dans le
meuble et un linteau afin déviter un endommagement éventuel de propriété et de
produit. Si ceci n'est pas possible, les ancrages muraux (non-fournis) doivent être
insérés avant d'installer les fixations.
Kohler Co.
Plus/Plus/Más:
• Wood Screws/Vis à bois/Tornillos para madera
• Framing Nails
Clous de cadrage
Clavos para estructuras de madera
3
1068637-2-B
Tabla de contenido
