Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Maintenance
Cleaning
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filter
before operating the hood.
Exterior surfaces
To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads.
Always wipe dry to avoid water marks
Cleaning method:
Liquid detergent soap and water, or all-purpose cleanser
•
Wipe with damp soft cloth or nonabrasive sponge, then
•
rinse with clean water and wipe dry.
Metal grease filter
The filters should be washed frequently. Place metal filters in
dishwasher or hot detergent solution to clean. Let filter dry
throughly before replacing it.
Turn off fan and lights. Allow lamps to cool.
1
Remove each filter by pulling the spring release handle
and then pulling down the filter.
A
2
Wash metal filters as needed in dishwasher or hot
detergent solution.
3
Reinstall the filter by making sure the spring release handles
are toward the front. Insert metal grease filter into upper
track.
4
Pull the spring release handle down.
5
Push up on metal filter and release handle to latch into place.
6
Repeat steps 1-5 for the other filter.
Replacing a LED lamp
The LED lights are replaceable by a service technician only.
See "Who to contact" section in the warranty for service
contact information.
.
Available accessories
Recirculating kit
If it is not possible to vent cooking fumes and vapors to the
outside, the range hood can be used in the non-vented
(recirculating) version, using a charcoal filter. Recirculation Kit
is available from the dealer or an authorized parts distributor.
A
G
B
J
D
F
E
H
A.
Ceiling
B.
Vent cover
C.
Soffit
D.
6" (15.2 cm) vent
E.
Range hood
NOTE: 12" (30.5 cm) high cabinets without a soffit may allow
the 6" vent and vent cover to be seen.
1
Cover the grill that protects the suction motor with the
carbon filter so that the slots on the filter correspond to
the pins on the sides of the motor protection grill.
2
Turn the carbon filter clockwise to block them (bayonet
fixing).
The charcoal filters cannot be cleaned. It should be
•
replaced every 4-6 months (depending on hood usage).
Remove the cable ties in the carbon filter to be able to
•
turning it clockwise.
Extension liner kit
30" wide x 17" or 20" deep liner provides complete
•
protection of the cabinets.
•
36" wide x 17" or 20" deep liner provides complete
protection of the cabinets.
See Liner installation instructions for more detail.
G
F
I
F.
Cabinet
G.
Wall
H.
12" (30.5 cm) min. cabinet height
I.
17" (43.2 cm) min. vent cover height
J.
Top of the cabinetry
A
B
C
D
E
11
Capítulos
Tabla de contenido
