Cub Cadet Snow Cab/Sun Shade Manual Del Operador página 6

NOTE: All references to LEFT, RIGHT, FRONT,
and REAR indicate the Snow Cab/Sun Shade
position when sitting in the tractor seat in the
operator's position.
CAUTION:
Do not transport the
tractor on a trailer or in the bed of a
truck with the snow cab or sun
shade installed.
Assembly
Before beginning installation, remove all parts
from the carton to make sure everything is
present. Carton contents listed on page 5.
NOTE: Some tractors will require the use of
the Snow Cab/Sun Shade Mounting Kit (#759-
05086) in order to install. The templates to drill
the required holes and instructions are on page 9.
To order the snow cab/sun shade mounting kit
see your authorized service dealer or contact
Customer Support.
1. Using two of the flange lock nuts (Ref. part
#11), two of the washers (Ref. part #15) and
one of the front canopy mount plates (#8),
mount the front left support (#6B) to the
frame of the tractor as shown in Figure 3-2.
Figure 3-2
6 S 3— A
ection SSembly
2. If your tractor is equipped with a drain hose
as shown below, the oil drain tube and clip
must be removed from the frame before
installing the front right support (#6A). See
Figure 3-3. The oil drain tube and clip will be
fitted onto the front right support bracket
when it is installed.
3. Repeat the mounting steps (Starting with
Step 1) on the right side of the tractor to
mount the front right support (#6A).
4. Install the oil drain tube clip onto the
front right support bracket (#6A) in the
mounting hole. See Figure 3-4.
& S -U
et p
Figure 3-3
Figure 3-4
5. Use two flange lock nuts (#10), two saddle
washers (#9), two flat washers (#14) and
two hex screws (#13) to mount the rear
support (#1) to the frame of the tractor as
shown in Figure 3-5.
Figure 3-5
6. Assemble the frame of the Snow Cab/Sun
Shade by connecting the numbered parts
as shown in Figure 3-1.
7. The frame pieces connect with a
spring clip inserted into the hole of the
connecting part to secure each piece
in place. Press down on the spring clip
button and slide it inside the connecting
piece until it snaps into the hole. See
Figure 3-6.
Figure 3-6
NOTE: Refer to Figure 3-1 for proper
location and assembly of the frame
pieces.