CARE AN D MAI NTE NANCE OF YOU R G RI LL
C l e a n i n g t h e B u r n e r A s s e m b l y
Follow these instructions to clean and/or replace parts of burner assembly or if you
have trouble igniting grill.
1 . Turn gas off at control knobs and LP cylinder.
2 . Remove cooking grates and heat tents.
3 . Remove carryover tubes and hardware securing burners.
4 . Detach electrode from burner.
NOTE: Removal/Detachment method will depend on the burner configura-
tion. See different configurations in illustrations below.
5 . Carefully lift each burner up and away from valve openings.
We suggest three ways to clean the burner tubes. Use the one easiest for you.
•
Bend a stiff wire (a light weight coat hanger works well) into a small
hook. Run the hook through each burner tube several times.
•
Use a narrow bottle brush with a flexible handle (do not use a brass wire
brush). Run the brush through each burner tube several times.
•
Wear eye protection: Use an air hose to force air into the burner tube
and out the burner ports. Check each port to make sure air comes out
each hole.
6 . Wire brush entire outer surface of burner to remove food residue and dirt.
7 . Clean any blocked ports with a stiff wire such as an open paper clip.
8 . Check burner for damage due to normal wear and corrosion, some holes may
become enlarged. If any large cracks or holes are found, replace burner.
VERY IMPORTANT: Burner tubes must re-engage valve openings. See illus-
tration below.
9 . Attach electrode to burner.
1 0 . Carefully replace burners.
1 1 . Attach burners to brackets on firebox.
1 2 . Reposition carryover tubes and attach to burners. Replace heat tents and cook-
ing grates.
1 3 . Before cooking again on grill, perform a "Leak Test" and "Burner Flame Check".
STEP 5: Example of a bent, stiff
wire for cleaning your burner.
STEP 10: CORRECT BURNER
TO VALVE ENGAGEMENT
FIREBOX
Electrode
Pa ge 10
CARRYOVER TUBE
FIREBOX BURNER
SUPPORT
Pry off electode with a
flat blade screwdriver.
C H A R B R O I L. C O M