Vacuum Packaging With A Bag - Turbosaver TS-3500 Manual De Usuario

III. Making a bag with bag roll
Put out the power cord and plug to the appliance and a wall outlet,Switch turn "ON",Va-
cuum screen and seal screen will display working time.Set suitable vacuum and sealing
time.
1. Pull out the bag roll and cutter to the suitable length you want.
2. Open the cover put one end of the bag on top of the sealing element and make sure that
the entire short end is under bag fixer.
3. Pull down the cover and touch "Seal" button to start make the bag. The vacuum screen
flashes display "0" and pump will work a few seconds,then the seal screen display counts
down to "0",then "sealing" indicator LED flashes a few seconds,indicator LED off if finish.
4. Lift the handle to open the cover. Remove the finished vacuum bag. The vacuum bag is
now ready to be used for vacuum packing.
II. Vacuum packaging with a bag
1. Put the items inside the bag.Clean and straighten the open end of the bag, make sure no
dust, wrinkle or ripples.
Note: Expel the extra empty air out of the bag after the bag is placed into the sealing bar inside the
chamber, this is a very important point to get a good vacuum sealed bag.
2. Open the cover put one end of the bag on top of the sealing element and make sure that
the entire short end is under bag fixer.
Note: When put the bag into the vacuum chamber, Please put the bag mouse encircle the splitter
plate toavoid the air cann't be draw out completed from the bag
20