Fitting The Handlebar - BH FITNESS H105 Instrucciones De Montaje Y Utilización

ASSEMBLY INSTRUCTIONS
Take the unit out of its box and make
sure that all of the pieces are there
Fig.1.
1.(1) Main body; (8) Handlebar stem;
(22) Saddle post; (23) Saddle; (15)
Handlebar; (24) Monitor; (3) Rear
stabiliser bar; (2) Front stabiliser bar; a
box containing the following: (4) Slot
head bolts M-10; (5) Curved washer
M-10; (6) Cap nut M-10; (13) Curved
washer M-8; (14) Allen screw; (16)
handlebar bracket, (17) screw M8;
(18) Bracket cover; (19) Handlebar
lever; (20) Flat washer M-8; (21)
Saddle post knob; (36) Allen key; (37)
Double ended ring spanner; (38)
Pedal spanner; (28) Left pedal; (29)
Right pedal.
2.Take the rear stabiliser bar (3) and
position it on the machine's rear stand
bracket, as shown in Fig.2, inserts
bolts (4), fit the curved washers (5) the
cap nuts (6) and tighten securely.
Take the front stabiliser bar with
wheels (2) and position it so that the
two red dots (A) line up, as shown in
Fig.2, insert bolts (4), fit the curved
washers (5) the cap nuts (6), and
tighten securely.

FITTING THE HANDLEBAR

Bring the handlebar (15) up to the
handlebar stem (8), Fig.3, insert the
hand-grip cable (26) in through the
slot as shown in Fig.3A and 3B, and
pull it out through the top of the
handlebar stem. Fit the handlebar
bracket (16), insert screw (17) and
hand tighten, put the washer (20) on
and the handlebar lever (19), position
the handlebar and tighten gently, then
fit the bracket cover (18).
FITTING THE MONITOR
Mod H-105.- Take the monitor (24) and
remove the four screws (25) from the
base of the monitor, Fig.4A, connect the
terminals for the feedback cables (30)
coming out of the monitor to the cable
(9) sticking up out of the handlebar
stem, Fig.4. Plug the terminal (26) which
is also sticking out of the handlebar
stem into the hole (26) on the base of
the monitor, then plug the terminal (33)
which is also sticking out of the
handlebar stem into the hole (33) on the
base of the monitor. Position the monitor
on the handlebar stem, making sure not
to catch any of the cables, and attach it
using the four screws (25) removed
previously.
Mod H-106 Program.- Take the monitor
(24), remove the four screws (25) from
the base, Fig.4B, connect the terminal
coming out of the monitor (12) with the
terminal for the cable (9) coming out of
the handlebar stem (8), next plug
terminal (26) which is also sticking up
from the handlebar stem into terminal
(35), position the monitor on the
handlebar stem, making sure not to
catch any of the cables, and attach it
using the four screws (25) removed
previously.
FITTING THE HANDLEBAR
STEM
Mod. H-105.- Hold the handlebar stem
(8) and connect the feedback cable
terminals (9) and (10) and the terminals
(33) and (34), Fig.5. Take the tension
cable (11) from the handlebar stem (8)
and connect it to the bottom tension
support (12), as shown in Fig.5A.
10