1. SPECIFICATIONS OF THE APPLIANCE
Voltage: 230 V~ 50 Hz
Insulation class: II
GB
Protection class IP24
Fan power
Model with symmetrical
[W]
Size
[ l x h mm ]
1000
550x1190 410 974
1000
550x1420 410 1205 550x1220 410 974 600x1528 410 1310 550x1345 410 1098
1000
550x1730 410 1513 550x1710 410 1469 600x1852 410 1635
A Brand/Manufacturer
B Model, type, category
C Voltage and Power
D Double isolation
2. GENERAL INFORMATION
Unpack the appliance carefully and rest it on the
polystyrene corner pieces or a soft support to avoid
damage.
The package contains:
– the appliance
– remote control with two batteries and container for
wall mouting
– mounting kit
– instructions
Read all the instructions carefully before installation
and use. Keep for future consultation.
Install and use the appliance as described in these
instructions only.
These instructions do not cover all situations which
might arise. Caution and common sense should be
applied when installing, operating and servicing the
appliance.
Modifying the characteristics of the appliance and
and/or removing or rotating the control device in any
way are expressly prohibited (Fig. 2).
Make sure the appliance is complete and undam-
aged. If damaged, do not use the appliance, but con-
Model with tube
flat tube
(Ø 25 mm)
A ( I )
B ( h )
Size
mm
mm
[ l x h mm ]
550x890
E Country of origin
F EC marking
G Serial Number
H Product Code
Model with asymmetrical
flat tube
A ( I )
B ( h )
Size
A ( I )
mm
mm
[ l x h mm ]
mm
410 608 600x1203 410 985
I
Protection class
L Quality marks
M Disposal procedures
3. POSITIONING AND INSTALLING
12
Model with symmetrical
flat tube (50x10 mm)
B ( h )
Size
A ( I )
B ( h )
mm
[ l x h mm ]
mm
mm
550x980
410 773 550x1056 410 798
-
-
-
The materials used for packaging can be recy-
cled. You are therefore recommended to dispose
of them in special differentiated waste collection
containers.
This appliance is designed to heat domestic rooms or
similar and to dry towels.
WARNING:
This appliance is designed to dry towels washed in water
only. It must not be used for other purposes. The appli-
ance must be used permanently mounted on a wall as
described in the instructions. Install the appliance with
the control device at the bottom right and the control
buttons towards the front as in Fig. 3.
Do not install the appliance with the fan facing up-
wards
In bathrooms (with bath or shower), install the ap-
pliance outside zone 1.
The appliance must be installed in such a way that
the electronic controls and other control devices
may not be touched by someone in the bath or
shower. The towel warmer must not be connected
with a plug.
For appliances already fitted with power
plugs, see the warnings on page 20.
Table 1
Model with tube
(Ø 22 mm)
Size
A ( I )
B ( h )
[ l x h mm ]
mm
mm
-
-
-
-
-
-