Assembly - Klutch NT359 Manual Del Operador

LOOSE PARTS LIST
See Figure 3, page 16.
The following items are included with the cut-off machine:
 Arbor Wrench ............................................................... 1
 14 in. Abrasive Wheel ................................................... 1
 Operator's Manual (not shown)
UNPACKING
This product has been shipped completely assembled.
 Carefully lift machine from the carton by the carrying
handle and the machine base, and place it on a level
work surface.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
WARNING:
Do not use this product if any parts on the Loose Parts List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 This machine has been shipped with the machine arm
secured in the down position. To release the machine arm,
push down on the top of the machine arm, and unhook
the transport chain. Hand pressure should remain on the
machine arm to prevent sudden rise upon release of the
transport chain.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 The machine is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has influ- enced the settings, refer to specific procedures explained
in this manual.
 If any parts are damaged or missing, please call
1-800-556-7885 for assistance.

ASSEMBLY

WARNING:
If any parts are damaged or missing, do not operate
this tool until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this tool or create accessories not
recommended for use with this tool. Any such alteration
or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is complete.
Failure to comply could result in accidental starting and
possible serious personal injury.
WARNING:
A 14 in. wheel is the maximum wheel capacity of the cut-
off machine. Never use a wheel that is too thick to allow
outer flange to engage with the flats on the spindle. Larger
wheels will come in contact with the wheel guards, while
thicker wheels will prevent the bolt from securing the wheel
on the spindle. Either of these situations could result in a
serious accident and can cause serious personal injury.
MOUNT TO A WORK SURFACE
See Figure 4, page 17.
The saw should be mounted to a firm supporting surface
such as a workbench. Bolt holes have been provided in
the saw base for this purpose. Each of the mounting holes
should be bolted securely using machine bolts, lock wash-
ers, and hex nuts (not included). Bolts should be of sufficient
length to accommodate the saw base, lock washers, hex
nuts, and the thickness of the workbench. Tighten all bolts
securely.
Carefully check the workbench after mounting to make sure
that no movement can occur during use. If any tipping, slid-
ing, or walking is noted, secure the workbench to the floor
before operating.
9 - English