Features - Klutch NT359 Manual Del Operador

PRODUCT SPECIFICATIONS
 Input ............................ 120 V, AC Only, 60 Hz, 15 Amps
 No Load Speed .................................3,900 r/min. (RPM)
 Arbor Diameter ........................................................ 1 in.
 Wheel Diameter ..................................................... 14 in.
KNOW YOUR CUT-OFF MACHINE
See Figures 1 - 2, page 16.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
14 in. ABRASIVE WHEEL
A 14 in. abrasive wheel is included with your cut-off machine. It will cut materials up to 5 in. thick or 8 in. wide, depending
upon the thickness or width of the material and the setting
at which the cut is being made.
ADJUSTABLE FENCE
The adjustable fence on your cut-off machine has been
provided to support the material and provide clamping
support to the vise for holding your material securely when
making all cuts. It adjusts from 0° to 45° to the right or left for
making angled cuts. The hole pattern allows it to be moved
forward when making cuts in tall or thick stock, such as
square stock or tube stock. The hole pattern allows it to be
moved back when making cuts in stock that is thin or wide,
such as angle stock.
ADJUSTABLE STOP
In the down (full cut) position, the pivot arm hits an adjust-
able stop on the support bracket.
ARBOR WRENCH
The arbor wrench is found on the side of the base. Use
wrench when replacing cut-off wheel or when making fence
angular adjustments.
CARRYING HANDLE
This handle is built into the unit to move it from one
location to another. Before attempting to pick up the unit by
the carrying handle always lock the power head in the down
position using the transport chain.

FEATURES

 Fence Angle ..................................... right (45°), left (45°)
 Maximum Cutting Capacities:
Round Pipe ............................... 5 in. outside diameter
Bar Stock .............................................................. 2 in.
LOWER WHEEL GUARD
The lower wheel guard provides protection from each side
of the wheel. Contact with the material causes the lower
guard to raise over the upper wheel guard as the wheel is
lowered into the material.
MITER LOCK HANDLE
Allows the adjustable fence to be pivoted at a given angle
then locked in place.
ON/OFF SWITCH
To start the tool, squeeze the trigger; release the trigger to
stop the tool. To prevent unauthorized use, install a padlock
through the hole in the trigger.
QUICK RELEASE LEVER
A quick release lever allows you to open and close the vise
clamp quickly without repetitive turning of the vise crank
handle.
SPINDLE LOCK
A spindle lock has been provided for locking the spindle
which keeps the wheel in your machine from rotating.
Only depress and hold the spindle lock when installing,
changing, or removing the wheel.
TRANSPORT CHAIN
The cut-off machine can be locked in the lowered position
for compact storage. The chain is only used during carrying
and storage operations.
UPPER WHEEL GUARD
Protects user from abrasive wheel contact on upper portion
of wheel.
VISE CLAMP
A vise clamp has been provided with your cut-off machine.
It is located on the end of the vise screw and provides
greater control by clamping the material to the fence. It also
prevents the material from creeping toward the wheel during
a cutting operation.
8 - English