Installing Globrite Light In A Vinyl Pool - Pentair GLOBRITE Manual Del Usuario

8
Installing GloBrite™ Light Niche in a Vinyl Pool
To install the GloBrite white light niche in a vinyl liner pool:
1. Drill a 7.62 cm (3 in) hole in the desired location for the light vinyl niche.
2. From the inside of the pool, insert the vinyl niche through the 7.62 cm (3 in)
hole.
3. Install the plastic nut onto the back of the niche. Hand tighten the nut to
secure the niche in place.
4. Place the sealing gasket onto the front of the niche as shown below.
5. Install the vinyl liner.
6. Install the conduit. See Figure 2 on page 7.
7. Using the alignment tabs on the niche, carefully align the faceplate to the
niche. Once the faceplate is properly aligned, pierce liner through faceplate
and install the screws one at a time.
8. Using a No. 2 Phillips head screwdriver, hand tighten each retaining screw to
secure the cover. DO NOT OVER TIGHTEN THE SCREWS. DO NOT USE
A POWER TOOL TO SECURE THE SCREWS. Over tightening or using a
2.54 cm (1 in) Conduit
GLOBRITE™ White LED Light Installation and User's Guide
Wall panel
Niche
Nut
Liner
Face Plate
Sealing Gasket
Stainless steel
screws (x4)